459133

BEKO WMB71432S Manual

54
Zoom out
Zoom in
Previous page
1/68
Next page
54
EN
theproductintoitsplaceafterinstallationor
cleaning procedures.
Appropriate installation location
• Placethemachineonarigidfloor.Donot
placeitonalongpilerugorsimilarsurfaces.
• Totalweightofthewashingmachineandthe
dryer-withfullload-whentheyareplaced
ontopofeachotherreachestoapprox.
180kilograms.Placetheproductonasolid
andflatfloorthathassufficientloadcarrying
capacity!
• Donotplacetheproductonthepowercable.
• Donotinstalltheproductatplaceswhere
temperaturemayfallbelow0ºC.
• Placetheproductatleast1cmawayfromthe
edgesofotherfurniture.
Removing packaging reinforcement
Tiltthemachinebackwardstoremovethe
packagingreinforcement.Removethepackaging
reinforcementbypullingtheribbon.
Removing the transportation locks
A
Donotremovethetransportationlocksbefore
takingoutthepackagingreinforcement.
A
Removethetransportationsafetyboltsbefore
operatingthewashingmachine,otherwise,
theproductwillbedamaged.
1. Loosenalltheboltswithaspanneruntilthey
rotatefreely(C).
2. Removetransportationsafetyboltsbyturning
them gently.
3. Attach the plastic covers supplied in the User
Manualbagintotheholesontherearpanel.
(P)
C
Keepthetransportationsafetyboltsinasafe
placetoreusewhenthewashingmachine
needstobemovedagaininthefuture.
C
Nevermovetheproductwithoutthe
transportationsafetyboltsproperlyfixedin
place!
Connecting water supply
C
Thewatersupplypressurerequiredtorun
theproductisbetween1to10bars(0.1–10
MPa).Itisnecessarytohave10–80litersof
waterflowingfromthefullyopentapinone
minute to have your machine run smoothly.
Attachapressurereducingvalveifwater
pressure is higher.
C
Ifyouaregoingtousethedoublewater-inlet
productasasingle(cold)water-inletunit,you
must install the supplied stopper to the hot
watervalvebeforeoperatingtheproduct.
(Appliesfortheproductssuppliedwithablind
stoppergroup.)
C
Ifyouwanttousebothwaterinletsofthe
product,connectthehotwaterhoseafter
removingthestopperandgasketgroupfrom
thehotwatervalve.(Appliesfortheproducts
suppliedwithablindstoppergroup.)
A
Modelswithasinglewaterinletshouldnot
beconnectedtothehotwatertap.Insuch
acasethelaundrywillgetdamagedorthe
productwillswitchtoprotectionmodeandwill
not operate.
A
Donotuseoldorusedwaterinlethoseson
thenewproduct.Itmaycausestainsonyour
laundry.
1. Connectthespecialhosessuppliedwiththe
producttothewaterinletsontheproduct.
Redhose(left)(max.90ºC)isforhotwater
inlet,bluehose(right)(max.25ºC)isforcold
waterinlet.
A
Ensurethatthecoldandhotwater
connectionsaremadecorrectlywhen
installingtheproduct.Otherwise,yourlaundry
willcomeouthotattheendofthewashing
processandwearout.
2. Tightenallhosenutsbyhand.Neverusea
wrenchwhentighteningthenuts.
3. Openthetapscompletelyaftermakingthe
hoseconnectiontocheckforwaterleaksat
theconnectionpoints.Ifanyleaksoccur,turn
offthetapandremovethenut.Retighten
thenutcarefullyaftercheckingtheseal.To
preventwaterleakagesanddamagescaused
bythem,keepthetapsclosedwhenthe
machine is not in use.
Connecting to the drain
• Theendofthedrainhosemustbedirectly
connectedtothewastewaterdrainortothe
washbasin.
A
Yourhousewillbefloodedifthehosecomes
outofitshousingduringwaterdischarge.
Moreover,thereisriskofscaldingdueto
highwashingtemperatures!Topreventsuch
situationsandtoensuresmoothwaterintake
anddischargeofthemachine,fixtheendof
the discharge hose tightly so that it cannot
… 54 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WMB71432S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMB71432S in the language / languages: English, German, French as an attachment in your email.

The manual is 3,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BEKO WMB71432S

BEKO WMB71432S User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info