Manual BEKO WMB 91442 (page 55 of 68) (English, German, Dutch, French)

475973

Zoom out

Zoom in

1/68

Removing the transportation locks

 Donotremovethetransportationlocksbefore

taking out the packaging reinforcement.

Remove the transportation safety bolts before

operatingthewashingmachine,otherwise,the

productwillbedamaged.

1. Loosenalltheboltswithaspanneruntilthey

rotate freely (C).

2. Remove transportation safety bolts by turning

them gently.

3. AttachtheplasticcoverssuppliedintheUser

Manual bag into the holes on the rear panel. (P)

Keep the transportation safety bolts in a safe

placetoreusewhenthewashingmachineneeds

to be moved again in the future.

 Nevermovetheproductwithoutthe

transportation safety bolts properly fixed in place!

Connecting water supply

 Thewatersupplypressurerequiredtorunthe

productisbetween1to10bars(0.1–10MPa).

Itisnecessarytohave10–80litersofwater

flowingfromthefullyopentapinoneminute

to have your machine run smoothly. Attach a

pressurereducingvalveifwaterpressureis

higher.

 Ifyouaregoingtousethedoublewater-inlet

productasasingle(cold)water-inletunit,you

mustinstallthesuppliedstoppertothehotwater

valve before operating the product. (Applies

fortheproductssuppliedwithablindstopper

group.)

 Ifyouwanttousebothwaterinletsofthe

product,connectthehotwaterhoseafter

removing the stopper and gasket group from

thehotwatervalve.(Appliesfortheproducts

suppliedwithablindstoppergroup.)

 Modelswithasinglewaterinletshouldnotbe

connectedtothehotwatertap.Insuchacase

thelaundrywillgetdamagedortheproductwill

switchtoprotectionmodeandwillnotoperate.

 Donotuseoldorusedwaterinlethoseson

thenewproduct.Itmaycausestainsonyour

laundry.

1. Connectthespecialhosessuppliedwiththe

producttothewaterinletsontheproduct.Red

hose(left)(max.90ºC)isforhotwaterinlet,blue

hose(right)(max.25ºC)isforcoldwaterinlet.

 Ensurethatthecoldandhotwaterconnections

aremadecorrectlywheninstallingtheproduct.

Otherwise,yourlaundrywillcomeouthotatthe

endofthewashingprocessandwearout.

2. Tightenallhosenutsbyhand.Neverusea

wrenchwhentighteningthenuts.

3. Open the taps completely after making the

hoseconnectiontocheckforwaterleaksatthe

connectionpoints.Ifanyleaksoccur,turnoff

the tap and remove the nut. Retighten the nut

carefullyaftercheckingtheseal.Topreventwater

leakages and damages caused by them, keep

thetapsclosedwhenthemachineisnotinuse.

Connecting to the drain

• Theendofthedrainhosemustbedirectly

connectedtothewastewaterdrainortothe

washbasin.

 Yourhousewillbefloodedifthehosecomesout

ofitshousingduringwaterdischarge.Moreover,

thereisriskofscaldingduetohighwashing

temperatures! To prevent such situations and to

ensuresmoothwaterintakeanddischargeofthe

machine, fix the end of the discharge hose tightly

so that it cannot come out.

• Thehoseshouldbeattachedtoaheightofat

least 40 cm, and 100 cm at most.

• Incasethehoseiselevatedafterlayingitonthe

floor level or close to the ground (less than 40 cm

abovetheground),waterdischargebecomes

more difficult and the laundry may come out

excessivelywet.Therefore,followtheheights

described in the figure.

• Topreventflowingofdirtywaterbackintothe

machineandtoallowforeasydischarge,do

notimmersethehoseendintothedirtywateror

driveitinthedrainmorethan15cm.Ifitistoo

long, cut it short.

• Theendofthehoseshouldnotbebent,itshould

not be stepped on and the hose must not be

pinchedbetweenthedrainandthemachine.

• Ifthelengthofthehoseistooshort,useitby

adding an original extension hose. Length of the

hose may not be longer than 3.2 m. To avoid

waterleakfailures,theconnectionbetweenthe

extension hose and the drain hose of the product

mustbefittedwellwithanappropriateclampas

not to come off and leak.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMB 91442 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WMB 91442 Manual

Product: