Manual BEKO WMB 71442 LMA (page 64 of 80) (English, German, Dutch, French)

528056

Zoom out

Zoom in

1/80

64 / EN

Washing Machine / User’s Manual

points.Ifanyleaksoccur,turnoffthetapandremovethe

nut.Retightenthenutcarefullyaftercheckingtheseal.To

preventwaterleakagesanddamagescausedbythem,

keepthetapsclosedwhenthemachineisnotinuse.

2.5 Connecting to the drain

• Theendofthedrainhosemustbedirectlyconnectedto

thewastewaterdrainortothewashbasin.

WARNİNG: Yourhousewillbefloodedifthehosecomes

outofitshousingduringwaterdischarge.Moreover,there

isriskofscaldingduetohighwashingtemperatures!

Topreventsuchsituationsandtoensuresmoothwater

intakeanddischargeofthemachine,fixtheendofthe

discharge hose tightly so that it cannot come out.

• Thehoseshouldbeattachedtoaheightofatleast40

cm, and 100 cm at most.

• Incasethehoseiselevatedafterlayingitonthefloor

level or close to the ground (less than 40 cm above the

ground),waterdischargebecomesmoredifficultandthe

laundrymaycomeoutexcessivelywet.Therefore,follow

the heights described in the figure.

• Topreventflowingofdirtywaterbackintothemachine

andtoallowforeasydischarge,donotimmersethehose

endintothedirtywaterordonotdriveitinthedrainmore

than15cm.Ifitistoolong,cutitshort.

• Theendofthehoseshouldnotbebent,itshouldnotbe

steppedonandthehosemustnotbepinchedbetween

the drain and the machine.

• Ifthelengthofthehoseistooshort,useitbyadding

anoriginalextensionhose.Lengthofthehosemay

notbelongerthan3.2m.Toavoidwaterleakfailures,

theconnectionbetweentheextensionhoseandthe

drainhoseoftheproductmustbefittedwellwithan

appropriate clamp as not to come off and leak.

2.6 Adjusting the feet

WARNİNG: Inordertoensurethattheproductoperates

more silently and vibration-free, it must stand level and

balancedonitsfeet.Balancethemachinebyadjusting

thefeet.Otherwise,theproductmaymovefromitsplace

and cause crushing and vibration problems.

1. Loosen the lock nuts on the feet by hand.

2. Adjust the feet until the product stands level and

balanced.

3.Tightenalllocknutsagainbyhand.

WARNİNG: Do not use any tools to loosen the lock nuts.

Otherwise,theywillgetdamaged.

2.7 Electrical connection

Connect the product to a grounded outlet protected by a 16

A fuse. Our company shall not be liable for any damages

thatwillarisewhentheproductisusedwithoutgroundingin

accordancewiththelocalregulations.

• Connectionmustcomplywithnationalregulations.

• Powercableplugmustbewithineasyreachafter

installation.

• Ifthecurrentvalueofthefuseorbreakerinthehouseis

less than 16 Amps, have a qualified electrician install a

16 Amp fuse.

• Thevoltagespecifiedinthe"Technicalspecifications"

section must be equal to your mains voltage.

• Donotmakeconnectionsviaextensioncablesormulti-

plugs.

WARNİNG: Damagedpowercablesmustbereplacedby

theAuthorizedServiceAgents.

Transportation of the product

1. Unplug the product before transporting it.

2.Removewaterdrainandwatersupplyconnections.

3.Drainallwaterthathasremainedintheproduct.

4.Installtransportationsafetyboltsinthereverseorderof

removalprocedure;

Nevermovetheproductwithoutthetransportationsafety

boltsproperlyfixedinplace!

WARNİNG: Packagingmaterialsaredangeroustochildren.

Keeppackagingmaterialsinasafeplaceawayfrom

reach of the children.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMB 71442 LMA in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,92 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WMB 71442 LMA Manual

Product: