Manual BEKO WMB 71241 S (page 14 of 56) (English, French)

550075

Zoom out

Zoom in

1/56

 Ifyouwanttoopentheloadingdoorafter

you have cancelled the programme but it

is not possible to open the loading door

since the water level in the machine is above

the loading door opening, then turn the

ProgrammeSelectionknobtoPump+Spin

programme and discharge the water in the

machine.

Machine is in Rinse Hold mode

Spin symbol flashes and Pause symbol

illuminateswhenthemachineisinRinseHold

mode.

Ifyouwanttospinyourlaundrywhenthe

machine is in this mode:

Adjust the spin speed and press Start / Pause

/ Cancel button. Pause symbol disappears and

Start symbol appears. Programme resumes,

discharges the water and spins the laundry.

Ifyouonlywanttodrainthewaterwithout

spinning:

Just press Start / Pause / Cancel button. Pause

symbol disappears. Start symbol appears.

Programme resumes and discharges the water

only.

End of programme

“End” appears on the display at the end of the

programme. Symbols of the programme steps

remain lit. Auxiliary function, spin speed and

temperature that were selected at the beginning

of the programme remain selected.

yourskinwhencleaning.Insertthedrawerback

into its place after cleaning and make sure that it

is seated well.

Cleaning the water intake filters

There is a filter at the end of each water intake

valve at the rear of the machine and also at

the end of each water intake hose where they

are connected to the tap. These filters prevent

foreign substances and dirt in the water to enter

the washing machine. Filters should be cleaned

as they do get dirty.

Close the taps. Remove the nuts of the water

intake hoses to access the filters on the water

intake valves. Clean them with an appropriate

brush.Ifthefiltersaretoodirty,takethemout

by means of pliers and clean them. Take out the

filters on the flat ends of the water intake hoses

together with the gaskets and clean thoroughly

under running water. Replace the gaskets and

filters carefully in their places and tighten the hose

nuts by hand.

Draining remaining water and

cleaning the pump filter

The filter system in your machine prevents solid

items such as buttons, coins and fabric fibers

clogging the pump impeller during discharge

of washing water. Thus, the water will be

discharged without any problem and the service

life of the pump will extend.

Ifthemachinefailstodrainwater,thepumpfilter

is clogged. Filter must be cleaned whenever it

is clogged or in every 3 months. Water must be

drained off first to clean the pump filter.

Inaddition,priortotransportingthemachine

(eg., when moving to another house) and in case

of freezing of the water, water may have to be

drained completely.

Foreign substances left in the pump filter

may damage your machine or may cause

noise problem.

Inordertocleanthedirtyfilteranddischargethe

water:

Unplugthemachinetocutoffthesupplypower.

Temperature of the water inside the machine

mayriseupto90ºC.Toavoidburningrisk,

filter must be cleaned after the water in the

machine cools down.

Openthefiltercap.

5 Maintenance and cleaning

Servicelifeoftheproductextendsandfrequently

faced problems decrease if cleaned at regular

intervals.

Cleaning the detergent drawer

Clean the detergent drawer at regular intervals

(every4-5washingcycles)asshownbelow

in order to prevent accumulation of powder

detergent in time.

Press the dotted point on the siphon in the

softener compartment and pull towards you until

the compartment is removed from the machine.

 Ifmorethannormalamountofwaterand

softener mixture starts to gather in the

softener compartment, the siphon must be

cleaned.

Wash the detergent drawer and the siphon with

plenty of lukewarm water in a washbasin. Wear

protective gloves or use an appropriate brush to

avoid touching of the residues in the drawer with

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMB 71241 S in the language / languages: English, French as an attachment in your email.

The manual is 3,41 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WMB 71241 S Manual

Product: