Manual BEKO WMB 61432 MU (page 60 of 76) (English, German, Dutch, French)

528060

Zoom out

Zoom in

1/76

60 / EN

Washing Machine / User’s Manual

2 Installation

RefertothenearestAuthorisedServiceAgentforinstallation

oftheproduct.Tomaketheproductreadyforuse,review

the information in the user manual and make sure that the

electricity,tapwatersupplyandwaterdrainagesystemsare

appropriatebeforecallingtheAuthorizedServiceAgent.If

they are not, call a qualified technician and plumber to have

any necessary arrangements carried out.

Preparationofthelocationandelectrical,tapwaterand

wastewaterinstallationsattheplaceofinstallationis

under customer's responsibility.

WARNİNG: Installationandelectricalconnectionsof

the product must be carried out by the Authorized

ServiceAgent.Manufacturershallnotbeheldliablefor

damages that may arise from procedures carried out by

unauthorized persons.

WARNİNG: Priortoinstallation,visuallycheckiftheproduct

hasanydefectsonit.Ifso,donothaveitinstalled.

Damaged products cause risks for your safety.

Makesurethatthewaterinletanddischargehoses

aswellasthepowercablearenotfolded,pinchedor

crushedwhilepushingtheproductintoitsplaceafter

installation or cleaning procedures.

2.1 Appropriate installation location

• Placethemachineonarigidfloor.Donotplaceitona

long pile rug or similar surfaces.

• Totalweightofthewashingmachineandthedryer-with

fullload-whentheyareplacedontopofeachother

reachestoapprox.180kilograms.Placetheproduct

on a solid and flat floor that has sufficient load carrying

capacity!

• Donotplacetheproductonthepowercable.

• Donotinstalltheproductatplaceswheretemperature

mayfallbelow0ºC.

• Placetheproductatleast1cmawayfromtheedgesof

other furniture.

2.2 Removing packaging reinforcement

Tiltthemachinebackwardstoremovethepackaging

reinforcement. Remove the packaging reinforcement by

pulling the ribbon.

2.3 Removing the transportation locks

WARNİNG: Do not remove the transportation locks before

taking out the packaging reinforcement.

WARNİNG: Remove the transportation safety bolts before

operatingthewashingmachine!Otherwise,theproduct

willbedamaged.

1.Loosenalltheboltswithasuitablespanneruntilthey

rotate freely (C).

2. Remove transportation safety bolts by turning them

gently.

3. Attach the plastic covers supplied in the User Manual bag

into the holes on the rear panel. (P)

Keep the transportation safety bolts in a safe place to

reusewhenthewashingmachineneedstobemoved

again in the future.

Nevermovetheproductwithoutthetransportationsafety

boltsproperlyfixedinplace!

2.4 Connecting water supply

Thewatersupplypressurerequiredtoruntheproductis

between1to10bars(0.1–1MPa).Itisnecessaryto

have10–80litersofwaterflowingfromthefullyopen

tap in one minute to have your machine run smoothly.

Attachapressurereducingvalveifwaterpressureis

higher.

Ifyouaregoingtousethedoublewater-inletproduct

as a single (cold)water-inletunit,youmustinstallthe

suppliedstoppertothehotwatervalvebeforeoperating

theproduct.(Appliesfortheproductssuppliedwitha

blind stopper group.)

WARNİNG: Modelswithasinglewaterinletshouldnotbe

connectedtothehotwatertap.Insuchacasethelaundry

willgetdamagedortheproductwillswitchtoprotection

modeandwillnotoperate.

WARNİNG: Donotuseoldorusedwaterinlethosesonthe

newproduct.Itmaycausestainsonyourlaundry.

1.Connectthespecialhosessuppliedwiththeproductto

thewaterinletsontheproduct.Redhose(left)(max.90

ºC)isforhotwaterinlet,bluehose(right)(max.25ºC)is

forcoldwaterinlet.

WARNİNG: Ensurethatthecoldandhotwaterconnections

aremadecorrectlywheninstallingtheproduct.

Otherwise,yourlaundrywillcomeouthotattheendof

thewashingprocessandwearout.

2.Tightenallhosenutsbyhand.Neveruseatoolwhen

tightening the nuts.

3. Open the taps completely after making the hose

connectiontocheckforwaterleaksattheconnection

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WMB 61432 MU in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,7 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WMB 61432 MU Manual

Product: