Manual BEKO WDIK854421F (page 13 of 56) (English)

817030

Zoom out

Zoom in

1/56

13 / EN Washer-Dryer / User Manual

• If the hose is run along the floor (or at less

than 40 cm above it) and raised later on,

water drain becomes difficult and laundry

may come out extremely wet. Therefore,

observe the heights described in the figure.

• To prevent flowing of dirty water back into

the machine and to allow for easy discharge,

do not immerse the hose end into the dirty

water or do not drive it in the drain more

than 15 cm. If it is too long, cut it short.

• The end of the hose should not be

bent, it should not be stepped on

and the hose must not be pinched

between the drain and the machine.

• If the length of the hose is too short, add an

original extension hose. Length of the hose

may not be longer than 3.2 m. To avoid water

leak failures, the connection between the

extension hose and the drain hose of the

product must be fitted well with an appropriate

clamp as not to come off and leak.

3.6 Adjusting the feet

CAUTION!

• Adjust feet so that the product will be

balanced in the location it will be used.

• Balance the machine by adjusting the feet.

• Check for any play by pressing the product

from upper diagonal edges.

• Otherwise, the product may move from

its place and cause crushing, noise and

vibration problems.

• Do not use any tools to loosen the lock

nuts. Otherwise, the lock nuts may get

damaged.

a) Loosen the lock nuts on the feet by hand.

b) Adjust the feet until the product

stands level and balanced.

c) Tighten all lock nuts again by hand.

Adjusting Rear Feet

• When you turn the knob (visible in the circle)

in the direction of the arrow, the machine

will be elevated by 0.3 mm. When you turn

it in the opposite direction of the arrow,

the machine will be lowered by 0.3 mm.

• Do not adjust the rear feet by

using chargeable devices. Use

a screwdriver instead.

Adjusting the feet with water level

• You must remove the Detergent

Drawer to set the Water Level.

• For the system to operate properly, the bubble

inside the Water Level must be in the

middle

• If the bubble inside the Water Level is

on the

left

, the pre-set

right

foot of the

Washing Machine must be adjusted.

• If the bubble inside the Water Level is

on the

right

, the pre-set

left

foot of the

Washing Machine must be adjusted.

• If the bubble inside the Water Level is at the

back

, the pre-set

front

feet of the Washing

Machine must be turned to the left (clockwise).

• If the bubble inside the Water Level

is at the

front

, the pre-set

front

feet

of the Washing Machine must be

turned to the right (anti-clockwise).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WDIK854421F in the language / languages: English as an attachment in your email.

The manual is 5.34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WDIK854421F Manual

Product: