762618
36
Zoom out
Zoom in
Previous page
1/44
Next page
36 / EN Washer-Dryer / User Manual
After every washing and
drying make sure that
no foreign substance is
left in the drum.
If the holes on the
bellow shown in the
figure are blocked,
open the holes using a
toothpick.
C
INFORMATION
Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents for
stainless steel. Never use steel wool or wire
wool.
A
CAUTION!
Never use sponge or scrub materials.
These will damage the painted, chrome
and plastic surfaces.
6.3 Cleaning the body
and control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents as
necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel.
6.4 Cleaning the water
intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to enter
the washing machine. Filters should be cleaned
if they are dirty.
1. Close the taps.
2. Remove the nuts of the water intake
hoses to access the filters on the water
intake valves. Clean residues on them
with an appropriate brush. If the filters are
too dirty, remove them from their places
with a pliers and clean in this way.
3. Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
4. Replace the gaskets and filters carefully
in their places and tighten the hose nuts
by hand ensuring there are no leaks.
6.5 Draining remaining water
and cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibres
clogging the pump impeller during discharge of
washing water. Thus, the water will be drained
without any problem and the service life of the
pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine
(e.g., when moving to another house) and in
case of freezing of the water, water may have to
be drained completely.
A
CAUTION!
Foreign substances left in the pump filter
may damage your product or may cause
noise problem.
If the product is not being used, shut the
tap, remove mains hose and drain the
water inside the machine in places where
there is the risk of the product freezing .
After each use, turn off the water tap to
which the mains hose is connected.
1. In order to clean the dirty filter and
discharge the water, unplug the
machine to cut off the supply power.
A
CAUTION!
Temperature of the water inside the
machine may rise up to 90 ºC. To avoid
the risk of burning, clean the filter after the
water inside the machine is cooled down.
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO WDER8540441G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WDER8540441G in the language / languages: English as an attachment in your email.

The manual is 5,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info