Manual BEKO WCC 7632 XS (page 16 of 20) (English)

676622

Zoom out

Zoom in

1/20

16 / EN

Washing Machine / User’s Manual

5.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve at the

rear of the machine and also at the end of each water intake

hose where they are connected to the tap. These filters

prevent foreign substances and dirt in the water to enter the

washing machine. Filters should be cleaned as they do get

dirty.

1 Close the taps.

2 Remove the nuts of the water intake hoses to access

the filters on the water intake valves. Clean them with an

appropriate brush. If the filters are too dirty, take them out

by means of pliers and clean them.

3 Take out the filters on the flat ends of the water intake

hoses together with the gaskets and clean thoroughly

under running water.

4 Replace the gaskets and filters carefully in their places

and tighten the hose nuts by hand.

5.5 Draining remaining water and cleaning the

pump filter

The filter system in your machine prevents solid items

such as buttons, coins and fabric fibers clogging the pump

impeller during discharge of washing water. Thus, the water

will be discharged without any problem and the service life

of the pump will extend.

If the machine fails to drain water, the pump filter is clogged.

Filter must be cleaned whenever it is clogged or in every 3

months. Water must be drained off first to clean the pump

filter.

In addition, prior to transporting the machine (e.g., when

moving to another house) and in case of freezing of the

water, water may have to be drained completely.

WARNING: Foreign substances left in the pump

filter may damage your machine or may cause noise

problem.

WARNING: If the product is not in use, turn the tap

off, detach the supply hose and drain the water inside

the machine against any freezing possibility in the

region of installation.

WARNING: After each use close the supply hose tap

of the product.

In order to clean the dirty filter and discharge the

water:

1 Unplug the machine to cut off the supply power.

WARNING: Temperature of the water inside the

machine may rise up to 90 ºC. To avoid burning risk,

clean the filter after the water in the machine cools

down.

2 Open the filter cap.

3 Some of our products have emergency draining hose and

some does not have. Follow the steps below to discharge

the water.

Discharging the water when the product has an

emergency draining hose:

a Pull the emergency draining hose out from its seat

b Place a large container at the end of the hose. Drain the

water into the container by pulling out the plug at the end

of the hose. When the container is full, block the inlet

of the hose by replacing the plug. After the container is

emptied, repeat the above procedure to drain the water in

the machine completely.

c When draining of water is finished, close the end by the

plug again and fix the hose in its place.

d Turn the pump filter to take it out.

Discharging the water when the product does not

have an emergency draining hose:

a Place a large container in front of the filter to catch water

from the filter.

b Loosen pump filter (anticlockwise) until water starts to

flow. Fill the flowing water into the container you have

placed in front of the filter. Always keep a piece of cloth

handy to absorb any spilled water.

c When the water inside the machine is finished, take out

the filter completely by turning it.

4 Clean any residues inside the filter as well as fibers, if

any, around the pump impeller region.

5 Install the filter.

6 If the filter cap is composed of two pieces, close the filter

cap by pressing on the tab. If it is one piece, seat the tabs

in the lower part into their places first, and then press the

upper part to close.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO WCC 7632 XS in the language / languages: English as an attachment in your email.

The manual is 2,75 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO WCC 7632 XS Manual

Product: