556379
10
Zoom out
Zoom in
Previous page
1/21
Next page
EN
9
3. Gently prise off plastic hinge covers
on both sides of front top panel using
a small flat-headed screwdriver. (1-2)
4. Unscrew the bolts of the top hinge
and remove top hinge. (3)
5. Remove door carefully off the
bottom hinge and stand door upright
in a safe place.(4)
6. Gently prise off plastic hinge cover
on door top trim. Fit the other door top
trim plastic off hinge cover supplied in
the plastic bag.(5)
7. Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this.Once you tilt the
appliance back, check to make sure
the appliance is completely stable and
safe before you carry on. (6)
8.Unscrew and remove the front feet
and 1 bolt. (7)
9. Unscrew and remove the bottom
hinge. (8)
10. Unscrew and remove the bottom
hinge door stopper and bushing and
reposition them on the other side while
rotating the bushing 180°. (9)
11. Fit the bottom hinge and tighten
the screws as shown in figure. (10)
12. Fit the other front feet as shown in
figure. (11)
13. Rotate the top hinge 180°.
Unscrew the hinge pin and re-tighten it
to the opposite side. (12)
14. Fit the top hinge on the left hand
side bushing of the door. (13)
15. Locate and re-fit door to bottom
hinge pin. (14)
16
. Re-fit the upper hinge on the opposite side
by using a flat headed screwdriver. (15)
17. Fit front top panel plastic hinge
covers on the opposite sides. (16)
18. Remove the handle cover gently
taking care not to damage the
appliance.(17)
19. Rotate 180 degrees and fit handle
to the other side after removing hole
plugs gently.(19)
20. Adjust the two front feet if
necessary.
21. Check that door opens and closes
easily, it is aligned correctly and there
are no gaps allowing air into the
cabinet. If here are gaps between the
door seal and the cabinet, adjust the
door seal by gently pulling away from
the door using fingers.
22. Check that all the hinge screws are
tightened. Avoid over tightening the
screws.
23. Put all items, fittings back in the
appliance.
24. Wait for at least 4 hours to allow
the system to settle before switching
on.
25. Once the correct storage
temperatures have been reached in
the appliance, put back all the food.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO TF546AP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO TF546AP in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info