Electrical requirements
Before inserting the plug into the wall socket
make sure that the voltage and the
frequency shown in the rating plate inside
the appliance corresponds to your electricity
supply.
We recommend that this appliance is
connected to the mains supply via a suitably
switched and fused socket in a readily
accessible position.
Warning! This appliance must be earthed.
Repairs to electrical equipment should only
be performed by a qualified technician.
Incorrect repairs carried out by an
unqualified person are carry risks that may
have critical consequences for the user of
the appliance.
ATTENTION!
This appliance operates with R 600a which
is an environmental friendly but flammable
gas. During the transportation and fixing of
the product, care must be taken not to
damage the cooling system. If the cooling
system is damaged and there is a gas leak
from the system, keep the product away
from ignition sources and ventilate the room
for a while.
WARNING - Do not use mechanical devices
or other means to accelerate the defrosting
process, other than those recommended by
the manufacturer.
WARNING - Do not damage the refrigerant
circuit.
WARNING - Do not use electrical
appliances inside the food storage
compartments of the appliance, unless they
are of the type recommended by the
manufacturer. WARNING - If the supply cord
is damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Transportation instructions
1. The appliance should be transported only
in an upright position. The packing as
supplied must be intact during
transportation.
2. The appliance should not be operated for
at least 4 hours after installation, to allow the
system to settle.
You may also need to alloww five minutes
between plugging in and switching on the
appliance.
3. Failure to comply with the above
instructions could result in damage to the
appliance, for which the manufacturer will
not be held liable.
4. The appliance must be protected against
rain, moisture and cold.
Important!
• Care must be taken while cleaning/carrying
the appliance not to touch the bottom of the
condenser metal wires at the back of the
appliance, as this could cause injury to
fingers and hands.
• Do not to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
WARNING - Make sure that the mains
cable is not caught under the appliance
during and after moving, as this could
damage the cable.
• Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1. Do not keep your appliance in a room
where the temperature is likely to fall below
10 degrees C (50 degrees F) at night and/or
especially in winter, as it is designed to
operate in ambient temperatures between
+10 and +43 degrees C (50 and 109
degrees F). At lower temperatures the
appliance may not operate, resulting in a
reduction in the storage life of the food.
2. Do not place the appliance near cookers
or radiators or in direct sunlight, as this will
cause extra strain on the appliance's
functions. If installed next to a source of heat
or freezer, maintain the following minimum
side clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3. Make sure that sufficient room is
provided around the appliance to ensure
free air circulation (Item 2).
• Open the door of your refrigerator to set
the distance between the refrigerator and
the wall (Item 3).
