676954

BEKO HCA62844ZH Manual

10
Zoom out
Zoom in
Previous page
1/260
Next page
10 / 242 EN
Hood / User Manual
Please consult the nearest Authorized Service
Agent for the installation of the hood.
*Preparation of location and electrical installation
for the product is under customer’s responsibility.
A
WARNING: Remove the protective
film (if any) on the hood and flue
surface after the installation.
The height between the lower surface of the hood
and upper surface of a hob should not be less than
50 cm for gas hobs and 45 cm for electric hobs.
Have a qualified electrician make the electrical
connection.
Install your product so that you can reach the
power connection (plug, outlet) easily after
installation.
Dimensions are given in mm.
3.1. Power connection
• Main power supply should comply with the
values indicated on the plate inside the hood.
Connect the hood to an outlet in compliance
with current regulations by means of a plug
and place it within an accessible area. After
installation; if device doesn't have a plug (direct
mains supply connection) or plug is out of reach,
use a double-pole switch in line with standards,
that enables disconnection of main plug under
circumstances related to overcurrent category
III.
A
WARNING: Before reconnecting
the hood to main power source and
checking if it functions correctly,
ensure that main power cable is
connected properly.
• The hood is equipped with a special power
cable. Contact Authorised Service Agent if the
the power cable is damaged.
3.2. Installation
3.2.1 Before you start
installation:
• Check that the product purchased has
appropriate sizes for installation location.
• Remove the active charcoal (*) filter if supplied
(see also relative paragraph). That/those will
only be installed if you want to use the hood as
a filtered model.
• Check if any other material (such as screw
package (*), warranty card (*) etc.) is delivered
in the hood and if available, remove them and
keep elsewhere.
• If possible, remove freestanding or sliding hob
and pull it aside in order to reach rear wall /
ceiling easily. If not possible, cover the bench,
hob or oven with a thick protective cloth in order
to secure them against damage and dirt. Select
a flat surface to install the appliance. Cover the
surface with a protective cloth and place all
awning hood parts and hardware in it.
• Besides; check if a plug is available on assembly
area of hood (besides, on the accessible
area after assembling the hood) and check if
connecting the hood to outside (only for the
model with aspiration) is possible.
• Finish all required operations related to wall
(e.g. plugging power plug and/or opening a hole
for discharge hose).
Wide dowels are available to allow for fixing
the hood on a variety of wall/ceiling types.
Additionally, conformity of material to wall/
ceiling type should be confirmed by a qualified
technician. Wall/ceiling should be able to sustain
the hood. Do not assemble the appliance on tile,
plaster or silicon surfaces. Assemble it only on to
a wall.
If a panel and/or side wall and/or furniture exist,
check that there is sufficient place for assembly
of hood and that control panel is easily accessible.
3 Installing your appliance
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO HCA62844ZH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO HCA62844ZH in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 27,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info