677671
8
Zoom out
Zoom in
Previous page
1/44
Next page
Cooker Hood / User Manual
8 / 41 EN
2 Important instructions for safety and environment
The symbol on the product or on the ac-
companying paperwork indicates that
the appliance should not be treated as
domestic waste, but should be delivered
to a suitable electric and electronic ap-
pliance recycling collection point. Follow local
guidelines when disposing of waste. For more in-
formation on the treatment, re-use and recycling
of this product, please contact your local authority,
domestic waste collection service or the shop
where the appliance was purchased.
Assembly and electrical connections must
be carried out by specialized personnel.
Wear protective gloves before proceeding
with the installation.
Electric Connection:
The appliance has been manufactured as a
class II, therefore no earth cable is necessary.
The plug must be easily accessible after the
installation of the appliance. If the appliance is
equipped with power cord without plug, a suit-
ably dimensioned Omni polar switch with 3 mm
minimum opening between contacts must be
fitted between the appliance and the electricity
supply in compliance with the load and current
regulations.
The connection to the mains is carried out as
follows:
BROWN = L line
BLUE = N neutral.
If the hob is electric, gas, or induction, the
minimum distance between the same and the
lower part of the hood must be at least 65 cm.
If a connection tube composed of two parts is
used, the upper part must be placed outside
the lower part.
Do not connect the cooker hood exhaust to the
same conductor used to circulate hot air or for
evacuating fumes from other appliances gener-
ated by other than an electrical source. Before
proceeding with the assembly operations, re-
move the anti-grease filter(s) (Fig.5) so that the
unit is easier to handle.
In the case of assembly of the appliance in the
suction version prepare the hole for evacuation
of the air.
We recommend the use of an air exhaust tube
which has the same diameter as the air exhaust
outlet hole. If a pipe with a smaller diameter
is used, the efficiency of the product may be
reduced and its operation may become noisier.
If your appliance has been designed for use in
habitations supplied with acentralised suction
device perform the following operations:
- The switch controls opening and closure of
a valve using a thermoelectrically device. By
placing the switch in the ON position, after a
minute, the valve opens rotating 90° allowing
suction of the stale air. By placing the switch
in the OFF position, the valve closes after 100
seconds.
3 Installing your appliance
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO H90X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO H90X in the language / languages: German, Dutch, French as an attachment in your email.

The manual is 6,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info