550072

BEKO EV 6800 Manual

9
Zoom out
Zoom in
Previous page
1/26
Next page
9 - EN
Starting the programme
PressStart/Pausebuttontostarttheprogramme.
Programme follow-up light showing the startup of
the programme will turn on.
Progress of programme
Progressofarunningprogrammecanbefollowed
from the Programme Follow-up indicator with the
lights "Running" and "End/Cancel".
C
Ifthemachinedoesnotpasstothespinning
step,automaticunbalancedloaddetection
systemmighthavebeenactivatedduetothe
unbalanceddistributionofthelaundryinthe
machine.
Loading door lock
There is a locking system on the loading door of the
machine that prevents opening of the door in cases
whenthewaterlevelisunsuitable.
Ifyouwanttoopenloadingdoorwhenthemachine
isinuse,press"Start/Pause"buttontopausethe
machine."DoorOpen"lightwillstartflashingwhen
the machine is switched to Pause mode. Machine
checksthelevelofthewaterinside.Ifthelevel
issuitable,"DoorOpen"lightilluminatessteadily
within1-2minutesandtheloadingdoorcanbe
opened.
Ifthelevelisunsuitable,"DoorOpen"lightturnsoff
andtheloadingdoorcannotbeopened.Ifyouare
obligedtoopentheloadingdoorwhenthe"Door
Open" light is off, you have to cancel the current
programme; see "Cancelling the programme".
Switching the machine to pause mode
Pressthe"Start/Pause"buttontoswitchthe
machine to pause mode while a programme is
running. "Running" light starts flashing on the
Programme Follow-up indicator to show that the
machinehasbeenswitchedtothepausemode.
Whentheloadingdoorisreadytobeopened,
"DoorOpen"lightwillilluminatecontinuously.
Adding or taking out laundry
Press"Start/Pause"buttontoswitchthemachine
topausemode.Whenthemachineisswitchedto
pausemode,"Running"lightflashes.Waituntilthe
LoadingDoorcanbeopened.OpentheLoading
Doorandaddortakeoutthelaundry.
ClosetheLoadingDoor.Press"Start/Pause"
buttontostartthemachine.
C
Thedoorcanbeopenedifthewaterlevelis
suitable.Dooropensymbolflashesuntilthe
loadingdoorgetsreadytobeopened.The
symbol'slightissteadywhenthedoorisready
to open. You can open the door to add/take
out laundry.
Cancelling the programme
To cancel the programme, turn the Programme
Selectionknobtoselectanotherprogramme.
Previousprogrammewillbecancelled."End/
Cancel" light will flash continuously to notify that the
programmehasbeencancelled.
C
Ifyoustartanewprogrammeaftercancelling
the previous one, this new programme will start
without draining the water in the machine.
C
Ifyoumustcertainlyopentheloadingdoor
whenthe“DoorOpen”lightisoff,youneed
to use "Spin+Pump" programme. See
"Spin+Pump"
Re-spinning the laundry
Unbalancedloadcontrolsystemcanprevent
spinningbecauseofunbalancedloadoflaundryin
themachine.Ifyouwouldliketospinagain:
Rearrange the laundry in the machine. Select
Spin+Pump programme and press “Start / Pause"
button.
End of programme
"End/Cancel" light on the programme follow-up
indicator will light up once the programme comes
toanend;and"DoorOpen"symbolflashesfor
1-2minutesuntilthedoorisreadytoopen.When
"DoorOpen"symbolissteadilyilluminated,the
doorcanbeopened.
To turn off the machine, turn program selection
knobto"On/Off"position.Takeoutyourlaundry
andclosetheloadingdoor.Themachinewillbe
ready for the next run.
Door Open
"DoorOpen"symbolisilluminatedwhenthedooris
readytoopen.Itflashesuntilthedoorgetsreadyto
open.Ifthe"DoorOpen"symbolisnotilluminated,
donotforcethedoortoopen.Thesymbol'slightis
steady when the door is ready to open.
5 Maintenance and cleaning
Servicelifeoftheproductextendsandfrequently
facedproblemsdecreaseifcleanedatregular
intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every4-5washingcycles)asshownbelowinorder
to prevent accumulation of powder detergent in
time.
Press the dotted point on the siphon in the softener
compartment and pull towards you until the
compartment is removed from the machine.
C
Ifmorethannormalamountofwaterand
softener mixture starts to gather in the softener
compartment,thesiphonmustbecleaned.
Washthedetergentdrawerandthesiphonwith
plentyoflukewarmwaterinawashbasin.Wear
protectiveglovesoruseanappropriatebrushto
avoid touching of the residues in the drawer with
yourskinwhencleaning.Insertthedrawerback
into its place after cleaning and make sure that it is
seated well.
Cleaning the loading door and the drum
Residues of softener, detergent and dirt may
accumulate in your machine in time and may cause
unpleasant odours and washing complaints. To
avoidthis,usetheDrumCleaningprogramme.
IfyourmachinedoesnothaveaDrumCleaning
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO EV 6800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO EV 6800 in the language / languages: English, French as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info