Manual BEKO EV 5100 plus Y (page 3 of 68) (English)

615079

Zoom out

Zoom in

1/68

3 / 68 EN

Washing Machine / User’s Manual

2 Installation

RefertothenearestAuthorisedServiceAgentforinstallation

oftheproduct.Tomaketheproductreadyforuse,review

the information in the user manual and make sure that the

electricity,tapwatersupplyandwaterdrainagesystemsare

appropriatebeforecallingtheAuthorizedServiceAgent.Ifthey

arenot,callaqualifiedtechnicianandplumbertohaveany

necessary arrangements carried out.

INFORMATIONS

Preparationofthelocationandelectrical,tapwaterandwaste

water installations at the place of installation is under customer’s

responsibility.

Make sure that the water inlet and discharge hoses as well as the

powercablearenotfolded,pinchedorcrushedwhilepushingthe

product into its place after installation or cleaning procedures.

B WARNING

Installationandelectricalconnectionsoftheproductmustbe

carriedoutbytheAuthorizedServiceAgent.Manufacturershallnot

beheldliablefordamagesthatmayarisefromprocedurescarried

outbyunauthorizedpersons.

A WARNING

Priortoinstallation,visuallycheckiftheproducthasanydefectson

it.Ifso,donothaveitinstalled.Damagedproductscauserisksfor

your safety.

2.1 Appropriate installation location

• Placethemachineonarigidfloor.Donotplaceitonalong

pile rug or similar surfaces.

• Totalweightofthewashingmachineandthedryer-with

full load- when they are placed on top of each other

reachestoapprox.180kilograms.Placetheproductona

solid and flat floor that has sufficient load carrying capacity!

• Donotplacetheproductonthepowercable.

• Donotinstalltheproductatplaceswheretemperaturemay

fallbelow0ºC.

• Placetheproductatleast1cmawayfromtheedgesof

other furniture.

2.2 Removing packaging reinforcement

Tiltthemachinebackwardstoremovethepackaging

reinforcement.Removethepackagingreinforcementby

pullingtheribbon.

2.3 Removing the transportation locks

A WARNING

Donotremovethetransportationlocksbeforetakingoutthe

packaging reinforcement.

Removethetransportationsafetyboltsbeforeoperatingthe

washingmachine!Otherwise,theproductwillbedamaged.

Loosenalltheboltswithasuitablespanneruntiltheyrotate

freely(C).Removetransportationsafetyboltsbyturningthem

gently.AttachtheplasticcoverssuppliedintheUserManual

bagintotheholesontherearpanel.(P)

INFORMATIONS

Keepthetransportationsafetyboltsinasafeplacetoreusewhen

thewashingmachineneedstobemovedagaininthefuture.

Nevermovetheproductwithoutthetransportationsafetybolts

properly fixed in place!

2.4 Connecting water supply

INFORMATIONS

Thewatersupplypressurerequiredtoruntheproductisbetween

1to10bars(0.1–1MPa).Itisnecessarytohave10–80liters

of water flowing from the fully open tap in one minute to have your

machinerunsmoothly.Attachapressurereducingvalveifwater

pressure is higher.

Ifyouaregoingtousethedoublewater-inletproductasasingle

(cold)water-inletunit,youmustinstallthesuppliedstopperto

thehotwatervalvebeforeoperatingtheproduct.(Appliesforthe

productssuppliedwithablindstoppergroup.)

Ifyouwanttousebothwaterinletsoftheproduct,connectthe

hot water hose after removing the stopper and gasket group from

thehotwatervalve.(Appliesfortheproductssuppliedwithablind

stopper group.)

A WARNING

Modelswithasinglewaterinletshouldnotbeconnectedtothe

hotwatertap.Insuchacasethelaundrywillgetdamagedorthe

product will switch to protection mode and will not operate.

Donotuseoldorusedwaterinlethosesonthenewproduct.Itmay

cause stains on your laundry.

Connectthespecialhosessuppliedwiththeproducttothe

waterinletsontheproduct.Redhose(left)(max.90ºC)isfor

hotwaterinlet,bluehose(right)(max.25ºC)isforcoldwater

inlet.

A WARNING

Ensure that the cold and hot water connections are made correctly

wheninstallingtheproduct.Otherwise,yourlaundrywillcomeout

hot at the end of the washing process and wear out.

Tightenallhosenutsbyhand.Neveruseawrenchwhen

tightening the nuts. Open the taps completely after making the

hose connection to check for water leaks at the connection

points.Ifanyleaksoccur,turnoffthetapandremovethenut.

Retighten the nut carefully after checking the seal. To prevent

waterleakagesanddamagescausedbythem,keepthetaps

closed when the machine is not in use.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of BEKO EV 5100 plus Y in the language / languages: English as an attachment in your email.

The manual is 1,82 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BEKO EV 5100 plus Y

BEKO EV 5100 plus Y User Manual - Spanish - 20 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

BEKO EV 5100 plus Y Manual

Product: