77361
7
Zoom out
Zoom in
Previous page
1/72
Next page
7 - EN
Important:
C There is no pump in the machine, so
ensure that the hose is placed to allow
a easy water flow.
C The end of the hose should never be
higher than the level of the water outlet
on the machine. Otherwise, the “tank
full” light of your machine will illuminate
and stop the programme.
C If the dryer is mounted on the washing
machine by means of a bracket, use of
the water drain hose is recommended.
The drain hose should be directed
downwards as shown in the figure.
Adjusting feet
In order to ensure that your product
operates more silently and vibration-
free, it must stand level and balanced on
its feet. Front feet of your product can
be adjusted. Balance the machine by
adjusting the feet.
1. Loosen the feet by hand.
2. Adjust the feet until the product stands
level and firmly on the floor.
CDo not use any tools to loosen the
adjustable feet, otherwise, they can be
damaged.
CNever remove the adjustable feet from
their housings.
2 plastic pieces supplied along with the
user manual prevent your machine from
slipping on wet and slippery surfaces. To
install the plastic parts:
1. Tilt your product to backwards.
2. Fit the plastic parts on to the front
adjustable feet. Press on the plastic
parts to snap them into their seating.
3. Check the balance of your product
again and readjust the adjustable feet if
necessary.
Electrical connection
Connect the machine to a grounded
outlet protected by a fuse of suitable
capacity as stated in the technical
specifications table. Our company shall
not be liable for any damages that will
arise when the machine is used on a
circuit without grounding.
Connection must comply with national
regulations.
If the current value of the fuse or
breaker in the house is less than 16
Amps, have a qualified electrician install
a 16 Amp fuse.
Power cable plug must be within easy
reach after installation.
The voltage and allowed fuse or
breaker protection are specified in the
“Technical Specifications” section.
The specified voltage must be equal to
your mains voltage.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO DV 2570 X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO DV 2570 X in the language / languages: English, German, French as an attachment in your email.

The manual is 3,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of BEKO DV 2570 X

BEKO DV 2570 X User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info