676969
8
Zoom out
Zoom in
Previous page
1/132
Next page
8 / 130 EN
Hood / User Manual
3.1 Drilling the Support surface and
Fitting the Hood
Screw Fitting
The hood support surface must be 135 mm
above the bottom surface of the wall units.
Drill the support with a ø 4,5 mm drill bit, using
the drilling template provided.
Cut a hole ø 120-150 mm in size on the sup-
port surface, using the drilling template provi-
ded.
Fix using the 4 screws 12a (4,2 x 44,4) provi-
ded.
3 Installation
Snap-On Fitting
The hood can be installed either directly on the
bottom surface of the wall units using snap-on
side supports.
Cut a fitted opening in the bottom surface of the
wall unit, as shown.
Insert the hood until the side supports snap into
place.
Lock in position by tightening the screws Vf
from underneath the hood.
Hood Type CTB 6250 W/B/X CTB 9250 X
L1 510 810
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO CTB9250X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO CTB9250X in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 18,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info