ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the
frequency shown in the rating plate inside the appliance corresponds to your electricity
supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance is connected to the mains supply via a suitable
switched and fused socket in a readily accessible position.
WARNING: When positioning the appliance ensure the supply cord is not trapped or
damaged.
Should the mains lead of the appliance become damaged or should it need replacing at
any time, it must be replaced by a special purpose made mains lead which can only be
obtained from a BEKO Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off
and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared
cord could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to
be replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not
forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be
used until a replacement fuse cover has been fitted. Colour of the replacement fuse
cover must be the same colour as that visible on the pin face of the plug. Fuse covers
are available from any good electrical store.
WARNING: Do not locate extension sockets or charging transformers/power supplies or
Lithium-Iron battery operated products adjacent to the compressor as they could
overheat.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug proceed as follows:
(See diagram).
1. Connect the green-yellow or green
(Earth) wire to the terminal in the plug
marked 'E' or with the symbol or coloured
green and yellow or green.
2. Connect the blue (Neutral) wire to the
terminal in the plug marked 'N' or coloured
black.
3. Connect the brown (Live) wire to the
terminal in the plug marked 'L' or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or
in the main fuse box.
If in doubt contact a qualified electrician.
WARNING: Do not locate extension sockets or charging transformers/power supplies or
Lithium-Iron battery operated products adjacent to the compressor as they could
overheat.
