757883
7
Zoom out
Zoom in
Previous page
1/20
Next page
Make sure that the mains cable is not caught under the appliance during and after moving, as this could
damage the cable.
• Do not allow children to play with the appliance or tamper with the controls. Beko plc declines to accept
any liability should the instructions not be followed.
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres.
2. This appliance has been designed to operate in ambient temperatures up to 38 degrees C (100 degrees
F) and is equipped with Freezer Guard technology which ensures that even if the ambient
temperature falls to -15°C, frozen food in the freezer does not thaw thanks to this. So, you may
then install your appliance in a garage or an unheated room without having to worry about frozen food in
the freezer being spoilt. However, at low ambient temperatures mentioned above, fridge contents are
likely to freeze, so check and consume food in the fridge accordingly. When the ambient temperature
returns to normal, you may change the knob setting to suit your needs. If the ambient temperature is
below 0°C, the food in the fridge compartment will freeze. So, we recommend you don’t use the fridge
compartment in such low ambient conditions. You can continue using the freezer compartment as usual.
3. Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to
work harder. If installed next to a source of heat or freezer, maintain the following minimum side clearances:
From Cookers
From Radiators
From Refrigerators or Larder Fridge
4. Make sure that sufficient room is provided
around the appliance to ensure free air circulation.
Fit the two plastic wall spacers supplied
with the appliance rotating 1/4 turn to
the condenser at the back of the
refrigerator (see diagram).
5. The fridge/freezer should be located on a smooth
surface. The two front feet can be adjusted as required.
To ensure that, your appliance is standing upright adjust
the two front feet by turning clockwise or anti-clockwise,
until the product is in firm contact with the floor. Correct
adjustment of feet avoids excessive vibration and noise.
6. Refer to cleaning and care section to prepare your
appliance for use.
WARNING!
Do not connect your appliance to the electricity supply until all
the packing and transit protectors have been removed including
polystyrene block(s) inserted between the compressor motor
and the cabinet (see diagram).
Do not remove the plastic drain tray fitted above the compressor
motor on models with auto - defrost fridge.
7. To take out the baskets from the freezer compartment please proceed as in item:
4
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO CCFM3571 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO CCFM3571 in the language / languages: English as an attachment in your email.

The manual is 0,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info