816661
13
Zoom out
Zoom in
Previous page
1/116
Next page
EN / 13
and water utilities are as required. If not, call
an electrician and plumber to arrange the
utilities as necessary.
WARNING:
The manufacturer assumes no re-
sponsibility for any damages caused
by the work carried out by unauthor-
ized persons.
WARNING:
The product’s power cable must be
unplugged during installation. Failure
to do so may result in death or seri-
ous injuries!
WARNING:
If the door span is too narrow for the
product to pass, remove the door
and turn the product sideways; if
this does not work, contact the au-
thorized service.
Place the product on a flat surface to
avoid vibration.
Place the product at least 30 cm away
from the heater, stove and similar sources
of heat and at least 5 cm away from elec-
tric ovens.
Do not expose the product to direct sun-
light or keep it in damp environments.
Your product requires adequate air circu-
lation to function efficiently. If the product
will be placed in an alcove, remember to
leave at least 5 cm clearance between the
product and the ceiling, rear wall and the
side walls.
Check if the rear wall clearance protection
component is present at its location (if
provided with the product).
If the component is not available, or if it is
lost or fallen, position the product so that
at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance at
the rear is important for efficient operation
of the product.
4.2 Electrical Connection
Do not use extension or multi sock-
ets in power connection.
Damaged power cable must be re-
placed by Authorized Service.
When placing two coolers in adja-
cent position, leave at least 4 cm
distance between the two units.
Our firm will not assume responsibility for
any damages due to usage without earth-
ing and power connection in compliance
with national regulations.
The power cable plug must be easily ac-
cessible after installation.
Do not use multi-group plug with or
without extension cable between the wall
socket and the refrigerator.
4.3 Hot Surface Warning
The side walls of your product are equipped
with cooler pipes to enhance the cooling
system. High pressure fluid may flow
through these surfaces, and cause hot sur-
faces on the side walls. This is normal and it
does not require servicing. Be careful when
you contact these areas.
4.4 Attaching the Plastic Wedges
Use the plastic wedges provided with the
product to maintain sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the
screws on the product and use the
screws provided with the wedges.
2. Attach 2 plastic wedges on the ventila-
tion cover as shown in the figure.
EN
FR
IT
NL
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BEKO B3RMFNE314W1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BEKO B3RMFNE314W1 in the language / languages: English, Dutch, French, Italian as an attachment in your email.

The manual is 2.42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info