615249
9
Zoom out
Zoom in
Previous page
1/16
Next page
9
Take apart the rear wheel
1. Turn the bike upside down so
the wheels are upward and the
handlebars are resng on the
ground.
2. Release the lock nuts holding
the back wheel onto the fork
of the bike frame. Use a 15 mm
wrench and work slowly to avoid
damaging the thread of the nut.
Pay good aenon to the order
of the washers. These need to
be in the exact order when
placing back the wheel.
3. Disconnect the brake cable and,
in case of V-brakes, open them.
4. Remove the plasc protecon
cap by loosening the two screws.
5. Pull the back wheel out
of the fork and lay it at on
table.
When placing back the wheel, rst ght-
en the nut on the right side of the bike.
Checklist:
Do the brakes work as they
should? Are the brake blocks
and bolts secure? Are the cables
intact?
Are the spokes at the right
tension?
Are the saddle tube and steering
tube not higher than the safety
markings?
All the nuts and bolts ghtened
securely?
Is the tread of the res not worn
out, are there any weak spots
or bulges and is the pressure
right?
Are the steering tube and the
handlebars secure? Is there any
play in the steering head?
Are the hand grips sll rmly in
place and do the gears sll work
awlessly?
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beixo 2013 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beixo 2013 in the language / languages: English as an attachment in your email.

The manual is 3,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info