660520
17
Zoom out
Zoom in
Previous page
1/22
Next page
17 XENYX XL3200/XL2400/XL1600 User Manual
6. Modications
These modifications require soldering. Attempt only if you are
experienced in using an iron on PCBs. Otherwise, refer to qualified
personnel. After modification the warranty becomes void.
We wish to be absolutely clear that BEHRINGER cannot be held
responsible after you start disassembling your XENYX. If you make
much of your warranty privileges, think again.
Links should not be threaded into the holes on the PCB, but are to
be soldered to the tinned areas around the holes. Bend the links a
little upwards.
6.1 Mon/Aux sends > post-EQ
Pre-fader switched monitor sends and aux sends are tapped o before the
equalizer. Do you prefer post-EQ? What are you waiting for? You don't have to
look far—the necessary information is found on the bottom side of the unit.
Make sure to turn off the mixer and disconnect it from the mains before
removing the cover.
1) Strip the PRE EQ lead.
2) Solder a POST EQ link into place.
3) Make these modications to as many channels as required (does it have to be
all of them?).
6.2 Direct Out > pre-fader
If you prefer to use the Direct Out pre-fader than post-fader, the signal needs
to be tapped o before the fader and not after the fader. To perform this
modication, nd the label “DIR-OUT” on the circuit board.
Make sure to turn off the mixer and disconnect it from the mains before
removing the cover.
1) Strip the POST FADER lead.
2) Solder a PRE FADER link into place.
3) Make these modications to as many channels as required.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Behringer Xenyx XL1600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Behringer Xenyx XL1600 in the language / languages: English as an attachment in your email.

The manual is 6,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Behringer Xenyx XL1600

Behringer Xenyx XL1600 Quick start guide - English, German - 18 pages

Behringer Xenyx XL1600 User Manual - German - 21 pages

Behringer Xenyx XL1600 User Manual - Dutch - 21 pages

Behringer Xenyx XL1600 Quick start guide - French, Portuguese, Spanish - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info