703103
23
Zoom out
Zoom in
Previous page
1/72
Next page
25 EN
Preparation
NOTES
Do not operate the device without water or with less water than is required to reach
the 8 oz mark (approx. 240 ml). If this does happen, the device switches off automa-
tically. In this case, allow the device to cool down before water is poured in and the
device is used again.
Never operate the device without a suitable vessel placed below the coffee outlet.
The lled to-go coffee cup (14) must not be transported in a bag or similar
carrier as it cannot be sealed so that it will not drip.
1. Fill the water tank (3) (see the “Handling and Operation” chapter | “Filling the Water
Tank).
2. Insert the lter insert (17) and the permanent lter (16) (see the “Handling and Operation”
chapter | “Inserting the Filter”).
3. Pour the amount of coffee powder you want into the permanent lter using a suitable
spoon. We recommend one heaped coffee measuring spoon (not supplied with the device)
per 125 ml.
4. Place the to-go coffee cup under the coffee outlet (4). Make sure that the cup lid (15) has
been opened. Otherwise the coffee cannot run into the to-go coffee cup.
You can also use any other vessel as long as it can hold at least 240ml and ts under the
coffee outlet.
5. Press the An / Aus (On / Off) button (7) to start the brewing process. The
and ON
symbols appear on the display (9). The red operating lamp (10) ashes during the brewing
process. The water is transported from the water tank through the permanent lter into
the to-go coffee cup and kept warm inside it.
After the end of the brewing process, the two symbols on the display and the red operating
lamp go out. The device automatically switches to stand-by mode.
If the brewing process is to be aborted prematurely, press the An / Aus (On / Off)
button. The device switches back to stand-by mode.
6. Take the to-go coffee cup off the deposit surface (6). Simply slide the slide closure on the
lid cup forwards or backwards to open or close the drink opening (Picture D).
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beem 03510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beem 03510 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info