810610
9
Zoom out
Zoom in
Previous page
1/20
Next page
9
GAS CONVERSION INSTRUCTIONS
GAS BOTTLE SAFETY
LPG SAFETY INFORMATION
5� Adjust primary air shutter (if necessary) by loosening the
adjustment screw and rotating shutter to achieve the
desired gap� Refer to “Primary Airation Gap” as defined
in Gas Specification table on page 6 for recommended
gaps for different gas types
6� Replace Burner and cover panel�
When changing gas types it may be necessary to adjust the
valve to achieve the desired turn down setting� This can only
be completed after the connection to the gas supply and leak
test has been conducted�
Adjust the turndown setting on the valve�
To complete the conversion the turndown setting of the valve
will need to be adjusted, and at the same time the operation
of the appliance can be tested� Proceed as follows:
Check that the burner ignites (REFER OPERATING
INSTRUCTIONS)�
Light the burner and rotate the control knob to the
lowest setting, then remove the knob from the valve
shaft, and remove the grommet�
Using a small flat-blade screwdriver adjust the
turndown adjustment screw to achieve a small steady
flame on the burner
Replace the grommet and the knob�
Recheck the operation of the burner at maximum
and turndown�
LPG safety information
Use only gas cylinders, which meet national and
regional codes� The minimum cylinder size for this
barbecue is 6kg� Ensure that the cylinder can provide
enough fuel to operate the appliance� If in doubt, check
with your local gas supplier
Pay attention that when changing the gas cylinder which
shall be carried our away from any source of ignition�
Never connect a cylinder, which does not meet
local codes�
All cylinders 7kg or larger must be placed on the ground
at the rear of the barbecue� Cylinders smaller than 7kg
(maximum size 465mm high by 306mm wide) may be
placed on the hook at the rear (as shown)� Cylinders
must not be exposed to extreme heat or direct sunlight�
The isolation valve must be turned off when the
appliance is not in use�
Gas cylinders must be stored in an approved housing out
of reach of children�
When disconnecting the gas bottle ensure that all the
control valves are in the ‘OFF’ position�
When reconnecting the hose to the bottle, ensure that
all connections are tight before replacing in storage
compartment�
Carry out a leakage check as detailed below after each
reconnection�
Only regulator which complies with EN 16129 can be
used�
The length of hose cannot exceed 1�5m� In Finland, the
length of hose cannot exceed 1�2m�
It’s necessary to change the flexible tube when the
national conditions require it, and/or depending on its
validity
Make sure that the flexible tube is not subjected to
twisting when the appliance is in operation�
Turndown adjustment screw
Burner
Primary
air shutter
Screw
Primary
air gap
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beefeater Proline Side Burner at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beefeater Proline Side Burner in the language / languages: English as an attachment in your email.

The manual is 2.17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info