810612
11
Zoom out
Zoom in
Previous page
1/28
Next page
11MOUNTING ENCLOSURE GUIDELINES
Mounting enclosure dimensions when installed with Beefeater hanging bracket BA70HS
Mounting enclosure dimensions when installed without hanging brackets
Enclosure construction
All materials used for the construction of the enclosure
and gas bottle compartment must be non-combustible.
A 40mm min. gap between the enclosure and rear wall
is required. This allows for venting of the gas bottle
compartment. Vents should also be positioned at the
front of the enclosure.
The cutout size specified above and below allow for
a 20mm gap between the back of the barbeque and
benchtop. This gap will help maintain air flow around
the barbeque.
The cutout sizes specified above are for use with the
Beefeater hanging bracket BA70HS. This bracket is
purchased separately as an accessory.
The cutout sizes specified below are for when the
product is installed without hanging brackets.
The product rests directly onto its base.
Enclosure ventilation requirements
AS5601 ventilation requirements for 9kg cylinder storage are:
Where of sheet metal or similar impervious construction
there shall be ventilation openings at the top and bottom
of the enclosure or recess, each opening providing a
free area of at least 200cm2 for every cylinder enclosed.
For LPG installations having enclosed cabinetry below
the separation panel that does not contain a gas bottle,
low level venting must be installed. This is to allow
the gas which is heavier than air to escape from the
enclosure in the situation where there may be a leak.
A minimum opening of 200cm2 is required.
Gas bottle size
This appliance is designed to be used with a gas
cylinder not exceeding 9kg (20lbs) capacity. The overall
size of the gas bottle should not exceed 315mm in
diameter and 460mm in height.
MOUNTING ENCLOSURE GUIDELINES
730mm 3 burner
680mm 3 burner
880mm 4 burner
830mm 4 burner
650mm min.
650mm min.
250mm250mm
604mm
604mm
40mm
gap min.
40mm
gap min.
1050mm 5 burner
1000mm 5 burner
Gas bottle
venting slots
Gas bottle
venting slots
Rear wall/splashback to be
non-combustible material
Rear wall/splashback to be
non-combustible material
Separation panel
Separation panel
930mm min.930mm min.
Gas bottle
venting slots
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Beefeater 1500 series - Built-in at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Beefeater 1500 series - Built-in in the language / languages: English as an attachment in your email.

The manual is 3.5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Beefeater 1500 series - Built-in

Beefeater 1500 series - Built-in User Manual - English - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info