765550
4
Zoom out
Zoom in
Previous page
1/24
Next page
4
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
INSTALLATION
Attention:
When smoke machine has a built-in fluid tank, then should be transport and operated in an upright position.
Use only Beamz water-based fluid recommended by your dealer. Poor liquid caused permanent damage, bad effect,
clogging, spitting of unevaporated liquid etc.
Be sure that the smoke machine is positioned on a stable, non-slip surface.
Be sure that no ventilation slots on the product’s housing are blocked.
Don’t put any objects on the smoke machine.
Always install the smoke machine in an area with adequate ventilation.
Never connect the smoke machine to a dimmer or rheostat.
In the event of a serious operating problem, stop using the product immediately.
When mounted at height, use the bracket and use add a safety cable.
The installation of the smoke machine has to be built and constructed in a way that it can hold 10 times the weight for 1
hour without any harming deformation.
The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.
Never aim the smoke at yourself, people or animals.
Never aim the output nozzle directly at people or at open flames.
The smoke machine has to be installed out of the reach of people and animals.
Drain the tank before transporting or storing the product.
Never drink smoke fluid or use it on the inside or outside of a human body. If fluid gets in contact with skin or eyes,
rinse thoroughly with water and call a doctor immediately!
Keep out of the reach of children.
For indoor use only.
CAUTION: Please consider the respective national norms during the
installation! The installation must only be carried out by an
authorized employee or dealers!
CAUTION: When installing the smoke machine, make sure there is no highly
in inflammable material (decoration articles, etc.) in between a
distance of min. 20inch or 0.5 meter.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for BeamZ 160.702 - Rage 600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of BeamZ 160.702 - Rage 600 in the language / languages: English, German, Dutch, French, Polish, Spanish as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info