1. Select adjust master fixture.
2. Press or to adjust select master value
1. Press on the remote controller.
2. Press or to adjust preset ID.
3. Press , , , , or (red, green, blue, white, amber or ultraviolet) to choose your colour.
3. Press again , , , , or (red, green, blue, white, amber or ultraviolet) to close your colour.
4. Press or to either increase or decrease the percentage of each colour.
Fade mode will enable colour gradiënt.
1. Press on the remote controller.
2. Press or to either increase or decrease the fade time.
Press digit to to select pre-program colour.
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the
battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the
remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
The fixture has a s built-in timer function. The fixture can show the pre-programmed preset, colour or chase at certain times and dates.
Adjust the battery turn of level on between 5-10%
- Press
- Select , press enter.
- Select , press enter.
- Select , press enter.
- Select percentage between 5 and 10% with the up and down buttons.
- Press to confirm.
Set the current date and time
- Press
- Select , press enter.
- Select , press enter.
- Select , press enter.
- Select the year with Up/Down buttons, press enter to select the month with Up/Down buttons, press enter to select the day with
Up/Down buttons.
- Press to confirm.
- Select , press enter.
- Select the hours with Up/Down buttons, press enter to select the minutes with Up/Down buttons, press enter to select the seconds with
Up/Down buttons.
- Press to confirm.
Set automatic turn On time
- Press
- Select , press enter.
- Select , press enter.
- Select , press enter.
- Select the hours with Up/Down buttons, press enter to select the minutes with Up/Down buttons, press enter to select the seconds with
Up/Down buttons.
- Press to confirm.
Set automatic turn Off time
- Press
- Select , press enter.
- Select , press enter.
- Select , press enter.
- Select the hours with Up/Down buttons, press enter to select the Minutes with Up/Down buttons, press enter to select the seconds with
Up/Down buttons.
- Press to confirm.
