INSTRUCCIONES
GEBRAUCHSANWEISUNG
INSTRUÇÕES
INSTRUCTIONS
INSTRUCTIONS
ISTRUZIONI
•
•
•
(Fig. 16-a)
e) Pull the shoulder belts through the belt
pads and belting slots in shell, ensuring that
the buckle remains fixed to prevent the belts
being twisted. (Fig. 17)
f) If you want to alter the belts from or to the
lowest positions, place the THUNDER to the
sleeping position.
g) If you want to alter the belts from or to the
higher positions, place the THUNDER to the
sitting position.
h) Place the shoulder pads at the expected
height and thread the shoulder straps back
through the shoulder pads, cover and shell.
(Fig. 18)
i) Connect the shoulder belts to the belt yoke.
(Fig. 19-a)
MAINTENANCE & CLEANING
General
a) The car seat can be cleaned by using luke-
warm water and soap. Do not use aggressive
cleaners like abrasives or thinner.
b)The cover should be washed by hand at a
maximum temperature of 30ºC. Do not put it
in the dryer.
c) It is advised to buy an extra cover when
purchasing the car seat that you can continue
using it when one cover is being washed.
Step 1: Take the car seat out of your car; en-
sure your entire baby’s car toys are put away
before you begin cleaning it.
Step 2. Suck up food particles and dirt with
a cordless vacuum. If possible, use a port-
able vacuum cleaner’s furniture attachment
to clean the small, hard-to-reach areas of the
car seat.
Step 3. Clean off the plastic portions of the
seat with gentle soap and water.
Step 4. Remove the entire car seat cover, if
possible, and run it through your washing ma-
chine gentle cycle.
Stpe 5. Spot clean the stained spots on the car
seat if you cannot remove the cover; make sure
you can use the soap on the car seat’s material
by checking the package’s guidelines.
Step 6. Reinstall the clean car seat in your car,
and take special care that all parts of the car
seat being present and installed safely and
correctly.
7 CHANGING THE COVER
Removing and Replacing the cover and belt
pads
a) Loosen the belts pads. (See adjusting the
height of the shoulder belts)
b) Loosen the cover all around. (Fig. 20)
c) Pull the belts, buckle tongues and buckle
through the cover.
d) Remove the cover.
e) After washing, attach the belt pads and
place the cover on the shell.
f) Thread the buckle, tongues and belts
through the cover and fasten the cover at the
release button/positioning handle.
g) Secure the cover on the pins.
h) Close the buckle and thread the belts
through the belt pads, cover and shell.
i) Connect the shoulder belts to the belt
yoke.
j) Fasten the cover all around, behind the
pins.
Checklist
For safety’s sake read through this checklist
before you set off.
Check that the harness belt system fits prop-
erly and tightly around your child and that the
shoulder belts are at the correct height.
Check regularly that the belt in the baby car
seat is not damaged. If it is damaged do not
use your product in any circumstances and
contact your supplier or importer (see ad-
dress list in the service card).
Check that you have secured your baby car
seat with the seat belt.
If you have any questions, please contact your
supplier
Make sure that you have the following details
to hand:
-Serial number underneath on the service
card.
-Mark and type of vehicle and seat on which
the baby car seat used.
-Age and weight of your child.
