109725
23
Zoom out
Zoom in
Previous page
1/32
Next page
9) Mark the position of the lower screw holes that need to be drilled
out in step 10. The holes can be found immediately below the motor
housing. (The position of one of the holes is indicated in the above
photograph by the screwdriver).
10) Remove the hood from the
mounting bar and then using a drill bit
with an 8 mm diameter, make holes in
the wall on the positions that you
marked in step 9.
11) Insert rawl plugs into the holes that you have just
drilled.
o Follow steps 7 and 8 again (i.e. rehang the hood
on the mounting bar and then adjust its angle and
height, so that the drilled holes line up with the
lower holes inside the hood again).
o From the inside of the hood, tighten screws into
the holes that you drilled in step 10.
o IMPORTANT: You must fully tighten these screws, as they
assist in fixing the hood to the wall.
23
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baumatic P 20 SS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baumatic P 20 SS in the language / languages: English as an attachment in your email.

The manual is 1,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info