332005
32
Zoom out
Zoom in
Previous page
1/36
Next page
Gas tap maintenance
32
These maintenance operations MUST ONLY be carried
e gas and electricity supplies.
o Remove the control knobs, pan supports, burners, hob fixing
op and remove any underside
protective covers.
ia panel and
separate the assembly. Then clean the cone and seating, with
smear the cone with high temperature grease,
reassemble into position and rotate a few times.
ne again and remove any excess grease,
making sure that the gas ducts are not obstructed with
o Carefully reassemble the components and perform a gas
it becomes necessary to replace a gas tap, then you should proceed
o Remove the control knobs, pan supports, burners, hob fixing
o Remove the hob from the worktop and remove any underside
ct the fixings holding the tap to the fascia panel and
separate the assembly.
o Disconnect the gas pipe from the gas tap, and then
ew tap, ensure that a new gasket is used.
out by a GASSAFE registered engineer.
IMPORTANT: Before carrying out any maintenance operations,
disconnect the appliance from th
If a gas tap becomes stiff to operate, then you should proceed as
follows:
screws and clamps.
o Remove the hob from the workt
o Disconnect the fixings holding the tap to the fasc
a cloth dampened with solvent.
o Lightly
o Remove the co
grease.
soundness test.
If
as follows:
screws and clamps.
protective covers.
o Disconne
disassemble them from the gas rail by removing the fixing
screws.
o When fitting a n
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Baumatic bt62 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Baumatic bt62 in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info