303906
2
Zoom out
Zoom in
Previous page
1/19
Next page
22
Before Using the Washing Machine
1.Removing the
Packaging and check
a.
Cut and remove the shrink-
wrap.
b.
Remove the top protection
and the protective corners.
c.
Remove the bottom protection
by tilting and turning the
washing machine on one rear
bottom corner.
d.
Open the lid by pressing it
slightly down while raising the
handle. Remove the
polystyrene cushion.
e.
Remove the blue protective
film from the panel
(depending on model).
After unpacking, make sure
that the washing machine is
undamaged. If in doubt, do
not use the washing machine.
Contact After-Sales Service or
your local retailer.
Keep the packaging materials
(plastic bags, polystyrene
parts, etc.) out of reach of
children; they are potentially
dangerous.
2.Remove the transport
bracket
The washing machine is fitted
with transport screws and a
transport bracket to prevent
damage during transport.
Before using the washing
machine you must remove
the transport bracket
(see
“Installation/Remove the
transport bracket”).
3.Install the washing
machine
Place the washing machine on
a flat and stable floor surface.
Adjust the feet to ensure that
the machine is stable and level
(see “Installation/Adjust the
feet”).
4.Water supply
Connect the water supply inlet
hose in accordance with the
regulations of your local water
company (see “Installation/
Connect the water inlet
hose”).
5.Drain hose
Connect the drain hose to the
siphon or hook it over the
edge of a sink with the “U”
bend (see “Installation/
Connect the water drain
hose”).
If the washing machine is
connected to a built-in
drainage system, ensure the
latter is equipped with a vent
to avoid simultaneous loading
and draining of water
(siphoning effect).
Fixed drainage stand pipe.
The internal diameter of the
drain pipe should be 3 cm
minimum. To avoid a syphon
effect, the end of the drain
hose should be 55 cm min.
from the floor.
6.Electrical connection
Electrical connections must be
carried out by a qualified
technician in compliance with
the manufacturer’s
instructions and the current
standard safety regulations.
The technical data (voltage,
power and fuses) are given on
the rating plate on the rear of
the washing machine.
The washing machine must be
connected exclusively by means
of a socket with an earth
connection in accordance with
current regulations. The washing
machine must be earthed by law.
The manufacturer declines all
liability for damage to persons or
property deriving directly or
indirectly from failure to observe
the directions.
Do not use extension leads or
multi sockets.
Before any maintenance on the
washing machine disconnect it
from the mains supply.
Access to the mains plug or to
disconnection from the mains
supply via a double-pole switch
must be ensured at all times
following the installation.
Do not operate the washing
machine if it has been
damaged during transport.
Inform the After-Sales Service.
Mains cable replacement is
only to be carried out by
After-Sales Service.
The washing machine must be
connected to an effective
earthing installation, in
compliance with the regulations
in force. In particular, washing
machines installed in premises
containing a shower or a bath
must be protected by a
differential residual current
device of at least 30 mA. Earthing
the washing machine is
obligatory under the law. The
manufacturer declines all liability
for damage to persons or
property deriving either directly
or indirectly from failure to
observe the directions above.
The washing machine may only
be used in the household for
the prescribed uses.
Dimensions:
Width: 400 mm
Height: 900 mm
Depth: 600 mm
Water supply: Cold water only
Tap: 3/4” threaded
hose connection
Pressure: 100-1000 kPa
(1-10 bar).
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht wats 5350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht wats 5350 in the language / languages: English as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht wats 5350

Bauknecht wats 5350 User Manual - German - 19 pages

Bauknecht wats 5350 User Manual - Dutch - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info