47550
12
Zoom out
Zoom in
Previous page
1/14
Next page
28
RECOVERING AN OBJECT THAT FALLS
BETWEEN THE DRUM AND THE TUB
If accidentally an object falls between the drum and
the tub you can recover it thanks to a removable
plastic lifter:
1.
Unplug the appliance.
2.
Remove the laundry from the drum.
3.
Close the drum flaps and turn the drum to the
opposite of the flaps.
4.
Press the plastic tip while sliding the plastic lifter
from left to right.
The plastic lifter will fall into the drum.
5.
Open the drum: through the hole inside the
drum you can recover the object.
6.
Refit the plastic lifter from inside the drum:
Position the plastic tip above the hole on the
right side of the drum.
Then slide the plastic lifter from right to left until
it clips.
7.
Plug in the appliance to the electrical outlet.
This appliance is equipped with safety functions
which detect faults at an early stage and react
appropriately.
Often, however, the faults detected are small
enough to be solved in a matter of minutes.
The appliance will not start, no lamp
lights up.
Check whether:
the appliance is plugged in;
the wall socket is functioning correctly (use a
table lamp or similar).
The appliance will not start, but the
Start lamp is flashing.
Check whether:
the appliance lid is properly closed;
a programme has been selected and the
programme is started.
the water tap is open.
The appliance stops during the
programme.
Check whether:
the Rinse Hold button is flashing, terminate
this option by pressing the button again;
another programme has been selected.
Reselect the desired programme and press the
Start/Pause button;
Start/Pause lamp is flashing. Press Start
button.
the door was opened and the Start/Pause
button is flashing. Press it again.
Safety system of the appliance was activated.
See fault description table on this page.
Detergent and additive product residues
in dispenser at end of wash.
Check whether:
the siphon is correctly installed and clean (see
Maintenance and Cleaning/ Detergent and
Additives);
enough water is being supplied. The mesh
filters could be clogged (see Maintenance and
Cleaning/ Water Hose Mesh Filters).
The appliance vibrates during the spin
cycle.
Check whether:
the appliance is level and solidly installed on all
feet (see Installation instructions);
the transport screws and transport bar have been
removed.
Before starting up the appliance, the transport
screws and the transport bar must be removed
(see Installation Instructions).
Final spin results are poor.
the appliance has an imbalance detection and
correction system. If individual heavy articles are
loaded (bathmat, bathrobe, etc.) this system may
reduce the spin speed automatically to protect
the appliance. It may even interrupt the spin cycle
altogether, if the imbalance is too great after
several spin starts;
if the laundry is too wet at the end of the cycle,
add more articles of laundry to balance the load
and repeat the spin cycle;
excessive foam formation may prevent spinning.
Use less detergent.
Check whether:
the pump impeller is obstructed (see Removing the
Foreign Body Trap) Fault Waterstop.
MAINTENANCE AND CLEANING
TROUBLESHOOTING GUIDE
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht WATE9575 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht WATE9575 in the language / languages: English as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht WATE9575

Bauknecht WATE9575 User Manual - German - 19 pages

Bauknecht WATE9575 User Manual - German - 14 pages

Bauknecht WATE9575 User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info