106342
3
Zoom out
Zoom in
Previous page
1/14
Next page
19
HOW TO UNPACK THE APPLIANCE
1.
Cut and remove the shrink-wrap.
2.
Remove the top protection and the protection corners.
3.
Remove the bottom protection by tilting and
turning the appliance on one rear bottom corner.
4.
Open the lid while pressing it slightly down and at
the same time operate the handle. Remove the
polystyrene cushion.
5.
Peel off the light blue protective film from the panel
(depending on model).
HOW TO REMOVE THE TRANSPORT
SCREWS AND THE TRANSPORT BRACKET
The appliance is fitted with the transport screws and
the transport bracket to prevent internal damage while
being moved.
Before using the appliance, the transport bracket
at the back MUST be removed.
1.
Unscrew the two screws
A
and the four screws
B
with
a flat screwdriver or a N° 8 hex nut screwdriver.
2.
Remove the transport bracket.
3.
Replace the four outer screws
B
into the machine
again and tighten.
4.
Tear off the two stop plugs
C
from the hose holder
and clip them into the openings of the machine
D
.
Note:
In case of future moves, always transport the
washing machine upright.
INSTALLATION
Install the appliance on a solid and level floor surface
close to electrical, water and drain connections.
Make sure that all feet are stable and resting on
the floor and then check that the appliance is
perfectly level (use a spirit level).
If the floor is uneven, adjust the levelling feet as
required (do not insert pieces of wood, cardboard
etc. under the feet).
The appliance can be installed in a 40 cm width
and 63 cm depth space.
Note:
It is important to avoid blocking the openings on
the underside of the appliance when installing on a
carpet floor.
ADJUSTMENT OF THE APPLIANCE
1.
To move the appliance into its operating position:
Pull the handle situated on the bottom of the front
(optional on certain models) a little bit by hand and
pull it in the final driving position by foot. Afterwards
push the handle back into the original, stable position.
The front feet can be adjusted in order to level the
appliance.
2.
Loosen the locknut using a wrench.
3.
Adjust the height of the foot, turning it by hand.
4.
Tighten the locknut by turning it anti-clockwise
towards the appliance casing.
IMPORTANT:
Do not run the appliance while it is
standing on the trolleys.
INSTALLATION INSTRUCTIONS
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht WAT 5340 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht WAT 5340 in the language / languages: English as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht WAT 5340

Bauknecht WAT 5340 Quick start guide - German - 14 pages

Bauknecht WAT 5340 User Manual - Dutch - 14 pages

Bauknecht WAT 5340 Quick start guide - French - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info