303896
2
Zoom out
Zoom in
Previous page
1/20
Next page
23
Before using the washing machine
1.Remove the packaging and
check
After unpacking, make sure
that the washing machine is
undamaged. If in doubt, do
not use the washing machine.
Contact After-Sales Service or
your local retailer.
Check that the accessories and
supplied parts are all present.
Keep the packaging materials
(plastic bags, polystyrene
parts, etc.) out of the reach of
children; they can constitute a
possible source of danger.
2.Remove the transit bolts
The washing machine is fitted
with a transport bolts to avoid
any possible damage to the
interior during transport.
Before using the washing
machine, the transport bolts
must be removed (see
“Installation/Remove the
transit bolts”).
3.Install the washing
machine
Remove the protective foil
from the control panel.
Move the appliance without
lifting it by the worktop.
Install the appliance on a solid
and level floor surface,
preferably in a corner of the
room.
Make sure that all feet are
resting correctly on the floor
and that the washing machine
is perfectly level and stable
(use a spirit level - see
Installation/Adjusting the
Feet).
4.Water inlet
Connect the water supply inlet
hose in accordance with the
regulations of your local water
company (see “Installation/
Connect the water inlet
hose”).
5.Drain hose
Connect the drain hose to the
siphon or hook it over the edge
of a sink by means of the “U”
bend (see “Installation/
Connect the water drain
hose”).
If the washing machine is
connected to a built-in
pumping out system, ensure
that the latter is equipped with
a vent to avoid simultaneous
loading and draining of water
(siphoning effect).
6.Electrical connections
Electrical connections must be
carried out by a qualified
technician in compliance with
the manufacturer's
instructions and local safety
regulations.
Data concerning voltage,
consumption and fuses are
located on the inside of the
appliance door.
The appliance must be
connected to the mains
exclusively by means of a socket
with an earth connection in
accordance with established
regulations. The washing
machine must be earthed by
law. The manufacturer declines
all responsibility for injury to
persons or pets, or damage to
property caused by non-
compliance with the above-
mentioned regulations.
Do not use extension leads or
multi sockets.
Before any maintenance on
the washing machine
disconnect it from the mains
supply.
Access to the mains plug or to
disconnection from mains
supply via a double-pole switch
must be ensured at all times
following the installation.
Do not operate the washing
machine if it has been
damaged during transport.
Inform the After-Sales Service.
Mains cable replacement is
only to be carried out by After-
Sales Service.
The washing machine must
only be used in the household
for the prescribed uses.
Minimum housing
dimensions:
Width: 600 mm
Height: 825 mm
Depth: 600 mm
Water inlet: Cold water only
Tap: 3/4 threaded
hose
connection
Water
pressure
(flow
pressure):
100-1000 kPa
(1-10 bar).
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht wae 8575 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht wae 8575 in the language / languages: English as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht wae 8575

Bauknecht wae 8575 User Manual - German - 20 pages

Bauknecht wae 8575 User Manual - Dutch - 19 pages

Bauknecht wae 8575 User Manual - French - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info