662980
9
Zoom out
Zoom in
Previous page
1/17
Next page
EN 8
DRAINING RESIDUAL WATER/
CLEANING THE FILTER
We recommend that you check and clean the filter
regularly, at least two or three times a year, especially:
If the “Clean pump” indication lights up.
If the appliance is not draining properly or if it fails to
perform spin cycles.
If the washing machine stands in a room prone to frost, you
have to drain residual water after each wash to avoid damages.
IMPORTANT: make sure the water has cooled before
draining the appliance.
1. Stop the appliance and unplug it.
2. To open the plinth (depending on the model):
- Push down the tabs right and left (if available) to
release the plinth and remove it (picture “A”).
- Remove the plinth by using the siphon insert of
the detergent dispenser: push downwards one
side of the plinth with your hand, then push the
siphon insert into the gap between plinth and
front panel and pry open the plinth (picture “B”).
3. Place a container near the washing machine.
4. If your washing machine has an emergency drain hose:
- Unclip the emergency drain hose.
If there is no emergency drain hose: place a broad,
flat container beneath the filter (picture D”).
Ignore steps 5-8 and proceed with 9.
5. Hold the emergency hose’s end into the container
and remove the stopper (picture “C”).
6. Wait until all the water has drained, then refix the
stopper at the hose’s end (picture “E”).
7. Refix the emergency drain hose (if available) to the clip.
8. Lay an absorbable cotton cloth (e.g. a towel) on the
floor in front of the filter.
9. Slowly open the filter by turning it counter-clockwise
(picture “F”); wait until all the water has drained, then
unscrew the filter completely and remove it.
10. Only for draining residual water: tilt the appliance
forwards carefully (a second person must help you)
to allow the water to flow out completely.
11. Only for cleaning the filter: clean the filter and the
filter chamber; check that the pump rotor in the filter
chamber moves freely.
12. Reinsert the filter and screw it in clockwise as far as
it will go.
13. Pour about 1 litre of water into the detergent
dispenser to reactivate the “Eco system”. Check that
the filter is inserted properly and securely and no
water comes out.
14. Reinstall the plinth (picture “G”); if necessary, tilt the
washing machine slightly backwards for doing that
(a second person must help you).
15. Plug in the washing machine. It is now ready for
operation again.
C
B
F
G
E
A
D
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht WA PLUS 844 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht WA PLUS 844 in the language / languages: English as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht WA PLUS 844

Bauknecht WA PLUS 844 User Manual - German - 15 pages

Bauknecht WA PLUS 844 User Manual - Dutch - 15 pages

Bauknecht WA PLUS 844 User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info