639006
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 401 05204
Add the detergent as described in the chapter
“Detergent and Additives” in the booklet.
1. Turn the
programme selector knob
in any
direction to the desired programme.
The remaining time display shows the duration
of the chosen programme (in hours and
minutes) and the pilot lamp above the
“Start/
Pause
button is flashing.
2. The programme sequence indicator and the
indicator with the maximum possible spin speed
light up.
3. The temperature can be altered by pressing the
“+”
or
“-”
button under the corresponding LED
display.
“Prewash” button
Only for heavily soiled laundry (for example sand
or granular dirt). Programme duration is
increased by some 15 min.
“Intensive Rinse” button
An additional rinse cycle is carried out.
This additional option is particularly suitable for
areas with very soft water, for washing baby
linen and helping people with detergent allergies.
“Rinse Hold” button
The laundry remains in the last rinse water
without being spun: discoloration of the laundry
and additional creasing are prevented.
This additional option is particularly
recommended for the programme “Synthetics
or “Delicate”.
This additional function is particularly useful if
you want to postpone spinning to a later time.
Note:
The programme has reached the “Rinse
Hold” when the “Rinse Hold” button light flashes.
Terminate the “Rinse Hold” option:
Press the “Rinse Hold” button again; the
programme will terminate automatically with the
appropriate spin cycle for the current
programme.
If you do not wish to spin the clothes, turn the
programme selector knob to “Drain/Cancel”
and press the
“Start/Pause”
button again.
“Speed Reduction” button
A maximum spin speed is assigned to each
programme.
Press the button to set another speed for the
spin cycle.
If the spin speed “0” is selected, the final spin is
cancelled. The water is only drained out.
CONSUMPTION DATA*
Programme Tem p e r a t u r e
(°C)
Wash
(kg)
Water
(l)
Energy
(kWh)
Programme duration **
approx.
(hours : minutes)
Cotton coloured 95 5.0 44*** 1.60 1:55
Cotton coloured 60 5.0 39 0.95 2:20
Cotton coloured 40 5.0 39 0.55 2:00
Synthetics 60 2.5 55*** 0.70 1:30
Synthetics 40 2.5 50 0.50 1:15
Daily Mixed 40 3.0 45 0.50 1:00
Delicate 30 1.5 50 0.50 0:45
Wool 40 1.0 50 0.50 0:40
Rapid wash 30 3.0 35 0.40 0:30
Handwash 30 1.0 35 0.40 0:35
*
Consumption values
were measured in normalized conditions in compliance with Standard IEC/EN 60456.
** The
programme duration
may also vary from the chart values. The washing machine is able to allow for particular household
conditions and to adapt the programme run time accordingly.
*** To reduce
the water temperature
, some cold water is
added at the end of the main wash cycle, before the pump drains the
water out.
POUR IN DETERGENT, CLOSE THE
DOOR AND SELECT A PROGRAMME
SELECT SPECIAL OPTIONS -
The indicator lights go on.
“Easy Ironing” button
To lessen creasing, the water quantity is
increased and the clothes are spun very gently at
reduced power. This makes your laundry
significantly damper at the end of the
programme.
The “Start Delay” allows to run the machine at the
consumer's convenience, for example at night when
electricity is cheaper.
Press the “Start Delay” button. Select the
programme start from 1 to 19 hours ahead by
pressing the button again.
•Press the
“Start/Pause
button. The Start
Delay indicator light flashes until the programme
starts.
During programme start the remaining time
appears in the digital display.
“Start Delay” correction.
Before the “Start Delay” has been started:
The preset number of hours can be altered by
continuously pressing the “Start Delay” button.
The number of hours can be reduced by first
turning the programme selector switch to the
Off” position. Then set the programme again
and select the desired number of hours.
After the “Start Delay” has been started:
The preset number of hours can be reduced by
pressing the “Start Delay” button again. To
increase the number of hours preselected, first
turn the programme selector switch to the “Off
position. Then set the programme and the
additional options again and select the desired
number of hours.
After you have selected the programme and the
additional option, the indicator light over the
“Start/Pause”
button flashes. Turn on the tap and
start the programme by pressing the
“Start/Pause”
button. Now the indicator light
above the button goes on.
In addition, all programme phases are indicated by
the associated lights. After the end of a programme
phase the associated indicator light goes out. Thus
the programme sequence indicator moves from left
to right across the wash, rinse and spin phases. At
the end of the programme only the “End” indicator
is still on.
In the first 15 minutes after the start of the “Cotton
coloured” and “Synthetic” programmes the door
can be opened to add further laundry. This is not
possible if “Rapid Wash” is selected.
The remaining time display shows “0:00” and the
“End” indicator lights up.
1. Turn the programme selector knob to the “Off”
position.
2. Turn off the tap.
3. Open the door and unload the machine.
A newly-selected programme will continue in the
same programme section during which the current
programme was interrupted. Therefore do not add
any more detergent.
1. Press the
“Start/Pause”
button to interrupt the
programme. The indicator light flashes.
2. Select the new programme (with temperature),
any additional options and - if you wish - another
spin speed.
3. Press the
“Start/Pause”
button again to restart
the programme.
•If you are in thePrewash” programme step this
additional option can not be deselected as
described (to do this see “Cancel/Delete
Programme).
1. Press the
“Start/Pause”
button to interrupt the
programme. The indicator light flashes.
2. Set the programme selector to “Drain/Cancel”.
The spin speed
“0”
and the remaining time “2
minutes” are displayed.
3. Press the
“Start/Pause”
button to start the
“Drain/Cancel” programme.
START DELAY
PROGRAMME START
DOOR LOCKED
PROGRAMME END
RESELECT AFTER PROGRAMME START
CANCEL/DELETE PROGRAMME
4gb05204.fm Page 2 Thursday, August 5, 2004 6:25 PM
Black process 45.0° 100.0 LPI
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht WA 75751 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht WA 75751 in the language / languages: English as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht WA 75751

Bauknecht WA 75751 User Manual - English - 14 pages

Bauknecht WA 75751 User Manual - German - 14 pages

Bauknecht WA 75751 Quick start guide - German - 2 pages

Bauknecht WA 75751 User Manual - French - 13 pages

Bauknecht WA 75751 Quick start guide - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info