302583
2
Zoom out
Zoom in
Previous page
1/8
Next page
10
Before Using the Dryer / Connections
1. Removing the packaging
and check
After unpacking, make sure
that the dryer is undamaged.
If in doubt, do not use the
dryer. Contact After-Sales
Service or your local retailer.
Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, as they are
potentially dangerous.
2. Electrical Connections
Electrical connections must
be carried out by a qualified
technician in compliance
with the manufacturer’s
instructions and current
standard safety regulations.
Electrical connection must
comply with local Electricity
Board regulations.
Voltage information, power
consumption and the
required fuse protection is
shown on the rating plate
mounted at the rear of the
dryer.
The manufacturer cannot
accept any liability for
personal injury or damage to
property resulting from
failure to adhere to these
instructions.
The dryer must be earthed as
prescribed by law.
Do not use extension leads or
multiple adaptors.
Before any maintenance on
the dryer disconnect it from
the mains supply.
Do not operate the dryer if it
has been damaged during
transport. Contact one of our
After-Sales Service
technicians.
Mains cables must be
replaced by an original cable
and is only to be carried out
by a technician from After-
Sales Service or an authorized
electrician.
After installation access to
the mains plug has to be
guaranteed, or the all-pole
disconnection has to be
possible with a switch.
3. Installation
Do not install your dryer
where it can be subject to
extreme conditions, such as:
poor ventilation,
temperatures around
freezing (or above 35°C).
Remove the protective foil
from the control panel.
Stability:
When installing the dryer
always carefully level the
dryer adjusting the two feet
and check the correct
levelling with a spirit level.
To built in the dryer
For security reason do not
remove the worktop.
Connect the dryer to an
external ventilation system in
order to prevent steam from
damaging your furniture
during the years.
Stacking kit
Your dryer can be stacked on
top of your front loading
washing machine.
To do this, use stacking kit
AMH 752, available at your
dealer.
Minimum housing
dimensions:
Width: 600 mm
Height: 850 mm
Depth: 560 mm
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht trak 6460 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht trak 6460 1 in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht trak 6460 1

Bauknecht trak 6460 1 Quick start guide - English - 2 pages

Bauknecht trak 6460 1 Quick start guide - German - 2 pages

Bauknecht trak 6460 1 User Manual - German - 7 pages

Bauknecht trak 6460 1 Quick start guide - Dutch - 2 pages

Bauknecht trak 6460 1 User Manual - Dutch - 7 pages

Bauknecht trak 6460 1 User Manual - French - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info