662965
11
Zoom out
Zoom in
Previous page
1/20
Next page
EN 9
CARE AND MAINTENANCE
Appliance exterior and control panel
Wash down with a soft, damp cloth. Dry with
a soft cloth.
Appliance interior
After each washing, leave the door open for some
time to allow the inside of the appliance to dry.
If you never or seldom wash your laundry at
95 °C, we recommend to occasionally run a
95 °C programme without laundry, adding a
small amount of detergent, to keep the interior
of the appliance clean.
Door seal
Dry the door seal after each washing with an
absorbent cotton cloth; make sure that the
door seal is completely dry before closing the
door of the empty washing machine.
Check the condition of the door seal
periodically.
Filter
Check and clean the filter regularly, at least two
or three times a year (see “Draining Residual
Water/Cleaning The Filter”).
Do not use detergents containing solvents, scouring powder, glass or general purpose
cleaners, and flammable fluids. They may harm the plastic surfaces or other parts.
Cleaning the detergent dispenser
1. Pull out the dispenser drawer until it stops. Press with your
finger on the small depression over the “PUSH” marking
(fig. “A”) to release the drawer and pull it out completely.
2. Remove the siphon from the softener chamber by pulling it
upwards (fig. “B”). If available, also remove the insert for liquid
detergent from the main wash chamber and remove the
coloured siphon part (fig. “C”).
3. Wash all the parts under running water.
4. Clean the dispenser compartment with a damp cloth.
5. Refit the siphon in the softener chamber by pushing it down
until it stops; if your washing machine has an insert for liquid
detergent, add the coloured siphon part to the insert again.
Then push the dispenser drawer back into the dispenser
compartment.
Water supply hose(s)
(picture D, E or F - depending on model)
Check regularly for brittleness and cracks. In case of a damage,
replace it by a new hose of the same type, available through our
After-Sales Service or your specialist dealer.
If the inlet hose of your washing machine corresponds with
the model on picture “E”, periodically check the safety valve
inspection window: if it is red, the hose’s waterstop function
was triggered, and the hose must be exchanged by a new one
from our After-Sales Service or your specialist dealer. This model
may have a release lever which must be pressed down while
unscrewing the hose.
If your supply hose has a transparent hose coating (fig. “F”),
periodically check the colour; if it intensifies locally, the hose may
have a leak and should be replaced. Contact our After-Sales
Service team or specialist dealer to obtain a replacement hose.
Cleaning the mesh filter in the water supply hose(s)
1. Close the tap and loosen the inlet hose on the tap.
2. Clean the internal mesh filter and screw the water inlet hose
back onto the tap.
3. Now unscrew the inlet hose on the rear of the washing machine.
4. Pull off the mesh filter from the washing machine connection
with universal pliers and clean it.
5. Refit the mesh filter and screw the inlet hose on again.
6. Turn on the tap and ensure that the connections are
completely water-tight.
B
C
D
E
F
Control window
Release lever
A
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht Super Eco 7415 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht Super Eco 7415 in the language / languages: English as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht Super Eco 7415

Bauknecht Super Eco 7415 Quick start guide - German - 4 pages

Bauknecht Super Eco 7415 User Manual - German - 18 pages

Bauknecht Super Eco 7415 Quick start guide - Dutch - 4 pages

Bauknecht Super Eco 7415 User Manual - Dutch - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info