662963
12
Zoom out
Zoom in
Previous page
1/12
Next page
ARBEITSPLATTE FÜR UNTERBAUMODELLE
Die Waschmaschine
darf nur
unter einer durchgehenden Arbeitsplatte eingebaut werden.
Die Waschmaschine
darf nur
mit der Zwischenabdeckung des Unterbausets UBS betrieben werden.
Diese ist im Fachhandel oder beim Kundendienst erhältlich.
1.
Netzstecker ziehen. Die Befestigungsschrauben der Arbeitsplatte an der
Waschmachinenrückwand entfernen.
2.
Arbeitsplatte ganz nach hinten schieben, hochheben und abnehmen. Das Unterbauset nach der
entsprechenden Anleitung montieren.
3.
Die Befestigungsschrauben wieder eindrehen. Die Waschmachine elektrisch anschließen.
WORKTOP FOR BUILT-UNDER MODELS
The appliance
must only
be installed beneath a continuous worktop.
The appliance
must only
be built under using the intermediate cover panel of the UBS base set. This
can be obtained from specialist dealers or After Sales Service.
1.
Pull out the mains plug. Remove the worktop fixing screws on the rear of the appliance.
2.
Slide the worktop fully backwards, lift it up and remove it. Install the UBS base set following the
relevant instructions.
3.
Refit the fixing screws and tighten them. Connect the appliance to the electricity.
PLAN DE TRAVAIL POUR LES MODÈLES ENCASTRÉS
L’appareil
doit être encastré
sous un plan de travail continu.
L’appareil
doit être
encastré en utilisant le panneau de protection intermédiaire de la série de base
UBS. Vous pouvez obtenir cet accessoire auprès de magasins spécialisés ou du Service Après-
vente.
1.
Débranchez l’appareil. Dévissez les vis fixant le plan de travail à l’arrière de l’appareil.
2.
Faites glisser le plan de travail vers l’arrière jusqu’à la butée et dégagez-le. Montez le panneau
intermédiaire UBS en suivant les instructions fournies.
3.
Replacez les vis de fixation et serrez-les. Branchez l’appareil à la prise de courant.
WERKBLAD VOOR ONDERBOUWMODELLEN
De wasmachine
mag uitsluitend
onder een doorlopend werkblad worden geïnstalleerd.
Het apparaat
mag alleen
worden ingebouwd met behulp van het tussenpaneel van de UBS
inbouwset. Deze kan worden verkregen bij de gespecialiseerde dealers of via de Klantenservice.
1.
Haal de stekker uit het stopcontact. Verwijder de bevestigingsschroeven voor het werkblad aan
de achterkant van het apparaat.
2.
Schuif het werkblad zo ver mogelijk naar achteren, til het op en verwijder het. Installeer de UBS
basisset volgens de desbetreffende instructies.
3.
Draai de bevestigingsschroeven opnieuw aan. Sluit het apparaat aan op het elektriciteitsnet.
PIANO DI LAVORO PER MODELLI DA INCASSO
Installare la lavatrice
solo sotto
un piano di lavoro continuo.
Utilizzare la lavatrice
solo
con il kit di montaggio base UBS che può essere richiesto ai rivenditori
specializzati o al Servizio Assistenza.
1.
Togliere la spina dalla presa di corrente. Togliere le viti di fissaggio del piano di lavoro nella parte
posteriore della lavatrice.
2.
Far scorrere completamente all’indietro il piano di lavoro ed estrarlo sollevandolo. Installare la
base UBS seguendo le relative istruzioni.
3.
Stringere nuovamente le viti di fissaggio. Collegare la lavatrice alla corrente elettrica.
5019 106 00793
10600793.fm Page 12 Friday, February 10, 2006 10:12 AM
Black process 45.0° 100.0 LPI
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht Super Eco 6412 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht Super Eco 6412 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht Super Eco 6412

Bauknecht Super Eco 6412 User Manual - English - 17 pages

Bauknecht Super Eco 6412 User Manual - German - 15 pages

Bauknecht Super Eco 6412 User Manual - Dutch - 15 pages

Bauknecht Super Eco 6412 User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info