662974
4
Zoom out
Zoom in
Previous page
1/8
Next page
INSTRUCTIONS FOR USE
ENERGY-SAVING TIPS
• Install the appliance in a dry, well ventilated room
far away from any heat source (e.g. radiator,
cooker, etc.) and in a place not exposed directly to
the sun. If required, use an insulating plate.
• To guarantee adequate ventilation follow
installation instructions.
• Insufficient ventilation on back of the product
increases energy consumption and decreases
cooling efficiency.
• The internal temperatures of the appliance may
be affected by the ambient temperature, frequency
of door opening, as well as location of the
appliance. Temperature setting should take into
consideration these factors.
• Allow warm food and drinks to cool down before
placing in the appliance.
• After placing the food check if the door of
compartments closes properly, especially the
freezer door.
• Reduce to a minimum door opening.
When thawing frozen food, place them in the
refrigerator. The low temperature of the frozen
products cools the food in the refrigerator.
• Damaged gasket must be replaced as soon as
possible.
• High energy class products are fitted with high
efficiency motors that remain operational for longer,
but have a low power consumption. Do not worry if
the engine continues to run for longer periods.
DESCRIPTION AND USE
DIAGRAM OF THE APPLIANCE (Fig. 1)
1. Lid handle.
2. Lock (if provided).
3. Seal.
4. Defrost water drain plug (depending on model).
5. Control panel.
6. Basket (depending on model).
7. Condenser (located at the rear).
INSTALLATION
Refer to chapter “Before using the appliance”.
• Unpack the appliance.
• Remove the 4 protection pieces inserted
between lid and appliance (Fig 3).
• Warning: two of the four protection pieces must
be fitted in the seat of the condenser plastic
supports, located at the rear of the product
(Fig. 3).
This is necessary to ensure the correct distance from
the wall.
• Ensure that the defrosting water drainage plug (if
provided) is correctly positioned (4).
• For best operation of the appliance and in order to
avoid damage when the lid is opened, leave a space
of at least 7 cm from the rear wall and 7 cm at the
sides.
• Fit the accessories (if provided).
DIAGRAM OF THE CONTROL PANEL (Fig. 2)
a. Red LED: when flashing, it indicates that an alarm
condition is present see TROUBLESHOOTING GUIDE"
b. Green LEDS: they indicate that the appliance is in
operation, and the temperature has been set as
follows:
Optimum less cold temperature (right light on), use
this setting with partial loads will optimize energy
consumption.
Normal middle temperature (center light on)
MAX very cold temperature (left light on)
ALL Green LEDs ON: FAST FREEZING function is
active; see the section “freezing fresh food”.
c. Temperature setting button: to adjust the set
temperature and to activate/deactivate the fast
freezing operations.
To select the desired temperature, repeatedly press
the setting button (3): each time the button is pressed,
the set temperature is updated.
To activate/deactivate fast freezing function, pressing
for approximately 3 seconds: all green LEDs flash
simultaneously 3 times and then remain lit.
Note:
The settings will be saved in the memory even if a
power cut occurs. The time needed for the
temperature inside the freezer to reach the set value,
can vary depending on climatic conditions and the set
temperature itself.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht GTE 206 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht GTE 206 in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht GTE 206

Bauknecht GTE 206 User Manual - German - 8 pages

Bauknecht GTE 206 User Manual - Dutch - 8 pages

Bauknecht GTE 206 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info