35370
10
Zoom out
Zoom in
Previous page
1/10
Next page
21
If a fault occurs, before contacting our After-Sales Service, make the following
checks to try and remedy the problem.
Restart the wash programme to see if the
fault repeats.
Press the
Start
button for about 5 seconds
until the
Start
indicator lamp switches off.
Briefly press the
Start
button.
If the malfunction persists, switch off the
appliance and turn off the water tap. Call our
After-Sales Service.
The appliance will not switch on:
Power plug properly inserted in the mains
socket?
Power failure?
Have you switched the dishwasher on?
Have you pressed the
Start
button?
Have you set the delay timer (if fitted)?
Tap turned on? If not:
Turn on the water tap.
Make sure the water hose filter is not
clogged.
To do this, turn off the water tap, disconnect
the water hose, clean the filter, reconnect
the water hose to the tap and turn on the tap.
Filters clogged?
Crockery loaded upside down?
When loading large items in particular, make
sure the water circulates and does not collect
inside them.
Door closed properly?
Fault indicated?
The
Start
indicator lamp or indicator lamp
F1...F9 flashes (depending on the model
installed), if a fault is detected. F9 flashes
(depending on the model installed), if a fault
is detected.
Other fault signals depending on the model
installed:
The indicator lamp on the control panel
flashes to indicate that the water-stop
system has tripped. Switch off the dishwasher,
disconnect the mains plug, turn off the water tap
and contact our After-Sales Service.
Crockery still dirty after washing:
Have you selected the correct programme?
Have you used the correct amount of
detergent?
Filters clogged or incorrectly assembled?
Spray arms blocked or nozzles clogged?
Salt container cap screwed down?
Crockery loaded correctly? (the water jets
must spray the entire surface of all items).
Spotted crockery:
Water hardness duly checked and
regulated?
Salt container empty?
Insufficient detergent?
Spotted glasses and cutlery:
Too much rinse aid? (Adjust the rinse aid
regulator to a lower setting).
Note:
On some models when the
Start
button is
pressed, a pre-rinse cycle is performed prior to
the actual wash programme to regenerate the
water softener system.
Before contacting our After-Sales
Service:
1.
try to remedy the problem (see
Troubleshooting guide).
2.
Switch off the dishwasher and restart the
wash programme to see if the fault repeats.
If, after carrying out the above checks the
malfunction persists, call our After-Sales
Service and specify:
the nature of the problem.
the appliance type and
model.
the service number
(the number after the
word Service on the
adhesive label) located
inside the door on the
right hand side.
your name, address and telephone number.
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
94004-gb.fm5 Page 21 Thursday, September 13, 2001 4:22 PM
10


Need help? Post your question in this forum.

Forumrules
1

Forum

bauknecht-gsx-4756

Reset search

  • Hi
    How do I remove a intergrated kitchen cabinet door from a auknecht gsx 4756 "integrated" dishwasher

    Thanks
    Graham Submitted on 1-4-2022 at 14:57

    Reply Report abuse
  • When i push on button the 3 lights will be on included the start button, how can i turn off the start button. Coz it can not be done , the start button is blinking . And i close the door , maschine can not run Submitted on 16-2-2020 at 13:01

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht GSX 4756 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht GSX 4756 in the language / languages: English as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht GSX 4756

Bauknecht GSX 4756 Quick start guide - English - 2 pages

Bauknecht GSX 4756 Quick start guide - German - 2 pages

Bauknecht GSX 4756 User Manual - German - 9 pages

Bauknecht GSX 4756 User Manual - Dutch - 9 pages

Bauknecht GSX 4756 User Manual - Dutch - 8 pages

Bauknecht GSX 4756 User Manual - French - 9 pages

Bauknecht GSX 4756 Quick start guide - French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info