449762
4
Zoom out
Zoom in
Previous page
1/7
Next page
14
ELECTRICAL CONNECTION
Electrical connection must be made before connecting the
appliance to the electricity supply. The appliance must be
installed by a qualified technician who is fully aware of current
safety and installation regulations. Specifically, installation must be
carried out in compliance with the regulations of the local
electricity supply company. Make sure that the voltage indicated
on the rating plate corresponds to the voltage in your home.
Regulations require that the appliance is earthed: use conductors
(including the earth conductor) of the appropriate size only. The
manufacturer declines all liability for injury to persons or animals
and for damage to property resulting from failure to observe the
above regulations. For the electrical connection use a H05RR-F
type cable as indicated in the table below:
Power supply voltage
If the hob is already equipped with a power supply cable,
see the electrical connection diagram shown in the
Product Description Sheet.
The appliance must be connected to the electricity supply
by means of an all-pole disconnect switch with minimum
contact gap of 3 mm.
Warning: the power supply cable must be long enough to allow
the cooktop to be removed from the worktop and must be
positioned so as to avoid damage or overheating caused by
contact with the base.
Terminal block connections
Note: the yellow/green earth wire must be connected to the
terminal with the symbol and must be longer than the other
wires.
Strip approx. 70 mm of the cable sheath from the power
supply cable (B).
Strip approx. 10 mm of sheath from the wires. First insert the
cable through the opening in the cover. Then insert the power
supply cable into the cable clamp and connect the wires to the
terminal block as indicated in the diagram printed on the
bottom of the cooktop.
Secure the power supply cable (B) by means of the cable
clamp.
Fit and secure the protective cover (A) which is screwed to
the lower face of the cooktop.
After the electrical connection, fit the hob from the top and
hook it to the support springs, according to the illustration.
Conductors Amount x size
230 V ~
3 X 2.5 mm
2
230 V 3~ +
4 X 1.5 mm
2
400 V 3N~ +
5 X 1.5 mm
2
400 V 2N~ +
4 X 1.5 mm
2
41902034GB.fm Page 14 Monday, October 11, 2010 11:25 AM
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht ETIH 5660 IN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht ETIH 5660 IN in the language / languages: English as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht ETIH 5660 IN

Bauknecht ETIH 5660 IN User Manual - German - 7 pages

Bauknecht ETIH 5660 IN User Manual - Dutch - 6 pages

Bauknecht ETIH 5660 IN User Manual - French - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info