591875
11
Zoom out
Zoom in
Previous page
1/16
Next page
EN11
Energy saving
For optimum results, it is advisable to:
Use pots and pans with bottom width equal to that of the cooking zone.
Only use flat-bottomed pots and pans.
When possible, keep pot lids on during cooking.
Use a pressure cooker to to save even more energy and time.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
Sugar or foods with a high sugar content damage the hob and must be immediately removed.
Salt, sugar and sand could scratch the glass surface.
Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer’s instructions).
Read and follow the instructions given in the section “Control panel description”.
Read the following table:
IMPORTANT: To avoid a permanent damage the hob:
- do not use pots with bottoms that are not flat;
- do not use metal pots with enamelled bottom;
- do not place hot pots/pans over the control panel.
CLEANING
WARNING
- Do not use steam cleaners.
- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”)
is not displayed.
TROUBLESHOOTING GUIDE
FAILURE DESCRIPTION POSSIBLE CAUSES MEASURE
The hob does not switch on
Missing power supply Check that power supply is on
Wrong connection of the main cable
Call a qualified technician to check the cable
connection
Hob failure Call after sales service
The hob switch on but "8" is shown
on each display
Strong light over the cooktop during start up
Reduce light over the control panel, restart
the hob (disconnect and reconnect to the
power supply)
Control panel damaged Call after sales service
Heater does not heat up but the display is on Hob failure Call after sales service
The hob plays 5 acustic signals and
then shut off
One or more buttons are continuously pressed
for more than 5 seconds
Remove any object or liquid that is placed
over the control panel
Not possible to switch the hob off Hob failure
Disconnect the hob from power supply and
call After sales service
The heater is not continuously on, it switches
on and off cyclically even if on the display the
power lever does not change.
Normal functioning of the hob
The on/off cycle allows the power regulation
of the heater and is completely normal. In
some cases a thermal protection could switch
off the heater for some time to avoid the glass
damage. Examples of such cases are: cooking
long time at high power level, usage of pots
smaller than the heating element, pot
bottoms not flat.
Not possible to use the hob,
"Lo" showed on the display
Control panel lock function active
Read the unlock instruction in "Control panel
lock" paragraph.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht ETCF 8640 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht ETCF 8640 in the language / languages: English as an attachment in your email.

The manual is 2,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht ETCF 8640

Bauknecht ETCF 8640 User Manual - German - 9 pages

Bauknecht ETCF 8640 User Manual - Dutch - 9 pages

Bauknecht ETCF 8640 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info