591913
4
Zoom out
Zoom in
Previous page
1/4
Next page
11
After-sales service
Before contacting After-Sales
Service:
1.
See if you can solve the problem
yourself with the help of
theTroubleshooting guide”).
2.
Switch off the hood for a few
minutes and re-start it to see if
the problem has cleared itself.
3.
If the malfunction persists, call
After-Sales Service.
Specify:
The nature of the problem.
The model.
The service code (number
below the word SERVICE on the
rating plate inside the hood
behind the grease filter).
Your full address.
Your telephone number and
area code.
Installation
When installing the hood, the
minimum distances from the
cooktop must be respected,
and the numerical sequence
and additional instructions
must be followed exactly as
indicated on the Installation
sheet.
External Exhaust Mode
(
A
- see also installation
sheet)
Cooking fumes and vapours are
conveyed outside through a
duct connected to the hood by
means of a collar.
The outlet duct diameter
must be the same as that of
the collar.
If a flue-damper is to be
installed, check that it can
open and close freely when
installation of the exhaust
duct is complete.
The hood can be supplied
with one (upper) or two
(upper and rear) exhaust
outlet holes.
The hood is usually set up
for using the upper exhaust
outlet.
1.
The collar must be seated in
the upper exhaust outlet.
Use the rear exhaust outlet
(where present).
1.
Where fitted, remove the
cover closing off the rear
outlet and collar.
2.
Some models are fitted with
a plastic deflector that
closes off the rear outlet. If
fitted, remove it.
3.
Fit the collar in the rear
outlet.
4.
Put the cover (if fitted) in
the upper outlet.
Warning!
If the hood has a
carbon filter, this should be
removed.
Check that the switch inside the
hood (if fitted) is in
position“A” Extractor; if not,
set it to this position.
Air Circulation Mode
(
F
- see also installation
sheet)
The air is filtered by a carbon
filter and recycled into the
surrounding atmosphere. The
filtered air is released towards
the kitchen ceiling.
Warning!
If the hood does
not have a carbon filter,
order one and fit it before
use.
Check that the switch inside the
hood (if fitted) is in position
“F” Filter
; if not, set it to this
position.
If the plug is provided, close off
the upper exhaust hole.
Electrical connection
Before connecting the hood,
make sure the voltage
indicated on the rating plate
corresponds to the voltage in
your home.
The plate is located inside
the hood behind the grille.
For GB this appliance is
supplied without a plug and is
intended for direct connection
to fixed wiring in accordance
with national wiring
regulations. An all-pole
disconnection switch with a
minimum contact separation
of 3 mm must be included in
the fixed wiring in an easily
accessible position.
The Manufacturer shall not
be liable for any damage or
problem arising from the
failure to comply with the
above-mentioned
instructions.
4Gb33005.fm5 Page 11 Friday, August 24, 2001 9:51 AM
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht DNV 5390 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht DNV 5390 in the language / languages: English as an attachment in your email.

The manual is 0,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht DNV 5390

Bauknecht DNV 5390 User Manual - German - 4 pages

Bauknecht DNV 5390 User Manual - Dutch - 4 pages

Bauknecht DNV 5390 User Manual - French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info