806826
11
Zoom out
Zoom in
Previous page
1/32
Next page
11
EN
INSTALLATION
The cooktop must be set into a worktop between 20
mm and 50 mm deep.
There must be nothing between the cooktop and
the oven (cross rails, brackets, etc.).
The distance between the lower face of the glass
ceramic hob and the cupboard or separating panel
must be at least 20 mm.
If the cooktop is to be installed next to a column
unit, leave a distance of at least 100 mm from the
edge of the cooktop to the side of the column unit.
For built-in dimensions and installation see the
pictures in this paragraph.
A minimum distance must be maintained between
the hob and the hood above it. Please refer to the
user manual of the hood for more informations.
Apply the supplied gasket to the cooktop (unless
it has already been fitted), after having cleaned its
surface.
Do not install the cooktop near a dishwasher or
washing machine, so that the electronic circuits do
not come into contact with steam or moisture, which
could damage them.
If an oven (from our range of ovens) is installed
beneath the cooktop, make sure that it is equipped
with a cooling system. If the temperature of
the electronic circuits exceeds the maximum
permitted temperature, the cooktop will switch off
automatically; in this case, wait for a few minutes
until the internal temperature of the electronic
circuits reaches a tolerable level, at which point it will
be possible to switch the hob on again.
30 mm
40 mm
PLACING THE HOB
After the electrical connection (see the chapter
“Electrical connection”). Position each fixing clips on
the dedicated slots on the lateral sides of the hob as
shown in the picture. Then push the hob inside the
cut out and check that the glass is flat and parallel to
the worktop. The fixing clips are designed for every
type of worktop material (wood, marble, etc).
490
515
R 5 MAX
289
270
57
+1
0
+1
0
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht CTAR 6360 IN-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht CTAR 6360 IN-1 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3.1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info