526795
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 401 05045
Add the detergent as described in the chapter
“Detergent and Additives” in the booklet.
1. Turn the programme selector knob in
any direction to the desired programme.
The remaining time display shows the
duration of the chosen programme (in
hours and minutes) and the pilot lamp
above the “Start/Pause”button is
flashing.
2. The programme sequence indicator and
the indicator with the maximum possible
spin speed light up.
3. The temperature can be altered by pressing
the “+” or “-” button under the
corresponding LED display.
“Prewash” button
Only for heavily soiled laundry (for example
sand or granular dirt). Programme duration is
increased by some 15 min.
“Intensive Rinse” button
An additional rinse cycle is carried out.
This additional option is particularly
suitable for areas with very soft water, for
washing baby linen and helping people
with detergent allergies.
“Rinse Hold” button
The laundry remains in the last rinse water
without being spun: discoloration of the
laundry and additional creasing are
prevented.
This additional option is particularly
recommended for the programme
“Synthetics” or “Delicates”.
This additional function is particularly
useful if you want to postpone spinning to
a later time.
Note: The programme has reached the
“Rinse Hold” when the “Rinse Hold” button
light flashes.
Terminate the “Rinse Hold” option:
Press the “Rinse Hold” button again; the
programme will terminate automatically
with the appropriate spin cycle for the
current programme.
If you do not wish to spin the clothes, turn
the programme selector knob to “Drain/
Cancel” and press the “Start/Pause
button again.
“Speed Reduction“ button
A maximum spin speed is assigned to each
programme.
Press the button to set another speed for the
spin cycle.
If the spin speed “0” is selected, the final
spin is cancelled. The water is only
drained out.
CONSUMPTION DATA
Programme Temperature
(°C)
Wash
(kg)
Water
(l)
Energy
(kWh)
Programme
duration **
approx.
(hours : minutes)
Coloured Cotton
95 5.0 44*** 1.60 1:55
Coloured Cotton
60 5.0 39 0.95 2:00
Coloured Cotton
40 5.0 39 0.55 2:00
Daily Mixed
40 3.0 46 0.58 1:00
Synthetic
60 2.5 55*** 0.70 1:30
Synthetic
40 2.5 50 0.50 1:15
Rapid wash
30 3.0 35 0.40 0:30
Delicate
30 1.5 50 0.50 0:45
Wool
40 1.0 50 0.50 0:40
Handwash
30 1.0 35 0.40 0:35
* Consumption
values
were measured in normalized conditions in compliance with Standard IEC 60456.
** The
programme duration
may also vary from the chart values. The washing machine is able to allow for
particular household conditions and to adapt the programme run time accordingly.
***To reduce
the water temperature
, some cold water is
added at the end of the main wash cycle, before
the pump drains the water out.
POUR IN DETERGENT, CLOSE THE
DOOR AND SELECT A PROGRAMME
SELECT SPECIAL OPTIONS -
The indicator lights go on.
“Easy Ironing” button
To lessen creasing, the water quantity is
increased and the clothes are spun very
gently at reduced power. This makes your
laundry significantly damper at the end of
the programme.
The “Start Delay” allows to run the machine
at the consumer's convenience, for example
at night when electricity is cheaper.
Press the “Start Delay” button. Select the
programme start from 1 to 19 hours
ahead by pressing the button again.
Press the “Start/Pause”button. The Start
Delay indicator light flashes until the
programme starts.
During programme start the remaining
time appears in the digital display.
“Start Delay” correction.
Before the “Start Delay” has been started:
The preset number of hours can be
altered by continuously pressing the
“Start Delay” button.
The number of hours can be reduced by
first turning the programme selector
switch to the “Off” position. Then set the
programme again and select the desired
number of hours.
After the “Start Delay” has been started:
The preset number of hours can be reduced
by pressing the “Start Delay” button again.
To increase the number of hours
preselected, first turn the programme
selector switch to the “Off” position. Then
set the programme and the additional
options again and select the desired
number of hours.
After you have selected the programme and
the additional option, the indicator light over
the “Start/Pause” button flashes. Turn on
the tap and start the programme by pressing
the “Start/Pause” button. Now the indicator
light above the button goes on.
In addition, all programme phases are
indicated by the associated lights. After the
end of a programme phase the associated
indicator light goes out. Thus the
programme sequence indicator moves from
left to right across the wash, rinse and spin
phases. At the end of the programme only
the “End” indicator is still on.
In the first 15 minutes after the start of the
“Cotton”, “Cotton coloured” and “Synthetic”
programmes the door can be opened to add
further laundry. This is not possible if “Rapid
Wash” is selecte.
The remaining time display shows “0:00”
and the “End” indicator lights up.
1. Turn the programme selector knob to the
“Off” position.
2. Turn off the tap.
3. Open the door and unload the machine.
A newly-selected programme will continue
in the same programme section during
which the current programme was
interrupted. Therefore do not add any more
detergent.
1. Press the “Start/Pause”button to
interrupt the programme. The indicator
light flashes.
2. Select the new programme (with
temperature), any additional options and
- if you wish - another spin speed.
3. Press the “Start/Pause”button again to
restart the programme.
If you are in the “Prewash” programme step
this additional option can not be deselected
as described (to do this see “Interrupt/Cancel
Programme).
1. Press the “Start/Pause”button to
interrupt the programme. The indicator
light flashes.
2. Set the programme selector to “Drain/
Cancel”. The spin speed “0” and the
remaining time “2 minutes” are displayed.
3. Press the “Start/Pause”button to start the
“Drain/Cancel” programme.
START DELAY
PROGRAMME START
DOOR LOCK
PROGRAMME END
RESELECT AFTER PROGRAMME START
CANCEL/DELETE PROGRAMME
4gb05045.fm Page 2 Wednesday, February 26, 2003 5:58 PM
Black process 45.0° 100.0 LPI
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht Berlin 1400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht Berlin 1400 in the language / languages: English as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht Berlin 1400

Bauknecht Berlin 1400 User Manual - English - 14 pages

Bauknecht Berlin 1400 User Manual - German - 15 pages

Bauknecht Berlin 1400 Quick start guide - German - 2 pages

Bauknecht Berlin 1400 User Manual - Dutch - 13 pages

Bauknecht Berlin 1400 Quick start guide - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info