806768
12
Zoom out
Zoom in
Previous page
1/13
Next page
14
EN
TROUBLESHOOTING
PROBLEMS POSSIBLE CAUSES SOLUTIONS
Display shows:
CHECK SALT! or
ADD SALT
Salt reservoir is empty. Rell reservoir with salt (see page 4).
Adjust water hardness (see page 4).
Display shows:
CHECK RINSE AID! or
ADD RINSE AID
Rinse aid dispenser is empty. Rell dispenser with rinse aid (see page 4).
... is not working / will not
start.
The appliance must be switched on.Check the household circuit fuse if there is no power supply.
The appliance door doesn’t close. Check if the appliance door is closed.
“Start Delay option is ON.
Check whether the „Start Delay” option has been selected. If it has, the
appliance will start once the set time has elapsed. If necessary, Reset
the current cycle by switching OFF the dishwasher, then switch it on
again, select a new cycle, press START and close the door within 4 sec.
Display shows: F6
symbol on the display
indicators
Water pressure is too low. The water tap must be fully open during water inlet (minimum capaci-
ty: 0.5 litres per minute).
Kinked water inlet hose or cloged
inlet lters.
The water inlet hose must not be kinked and the inlet lter in the water
tap connector must not be dirty or clogged.
Display shows: F3
Dirty lters. Clean the lters.
Kinked drain hose. The drain hose must not be kinked.
Syphon hose connection closed. The closure disk of the syphon hose connection must be removed.
Display shows: F2
Dirty lters or spray arms. Clean lters and spray arms.
Too little water in the appliance
system.
Concave items (e.g. bowls, cups) must be arranged facing downwards
in the rack.
Drain hose incorrectly tted.
The drain hose must be tted correctly (for high mounted appliances,
leave min. 200 - 400mm from the lower edge of the appliance) - see
Installation.
High level of foam inside. Repeat without detergent or wait until foam disappears.
Water pressure is too low. The water tap must be fully open during water inlet (minimum capaci-
ty: 0.5 litres per minute).
Kinked water inlet hose or cloged
inlet lters.
The water inlet hose must not be kinked and the inlet lter in the water
tap connector must not be dirty or clogged.
Display shows:
PRESS START AND
CLOSE THE DOOR
Door is not closed within
4 seconds of button press. Press again and close the appliance door within 4 seconds.
Display shows:
OPEN AND CLOSE
THE DOOR
The door was not open between
cycles. Unload appliance (if not unloaded before), open and close the door.
Display shows: Fx Appliance has technical defect. Call customer service (state fault displayed).
Close the water tap.
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list.
For other errors or issues please contact authorized After-sales Service which contact details can be found in the warranty booklet.
Spare parts will be available for a period of either up to 7 or up to 10 years, according to the specic Regulation requirements.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht BCIF 5O539 PLET at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht BCIF 5O539 PLET in the language / languages: English as an attachment in your email.

The manual is 7.57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht BCIF 5O539 PLET

Bauknecht BCIF 5O539 PLET User Manual - German - 13 pages

Bauknecht BCIF 5O539 PLET User Manual - Dutch - 14 pages

Bauknecht BCIF 5O539 PLET User Manual - French - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info