722504
7
Zoom out
Zoom in
Previous page
1/8
Next page
EN
7
CLEANING AND MAINTENANCE
EXTERIOR SURFACES
Clean the surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
oven to cool completely and then wipe it with a cloth
or sponge.
To remove the remaining limescale from the bottom
of the cavity after
cooking, we recommend
to clean the cavity with the products provided
by After Sales Service (please follow instructions
attached to the product).
Cleaning is recommended at least every 5 to 10
cooking cycles.
The door can be easily removed and refitted to
facilitate cleaning of the glass
Clean the glass in the door with a suitable liquid
detergent.
The top heating element of the grill can be lowered
to clean the upper panel of the oven: Extract the
heating element from its seating, then lower it. To
return the heating element to its position, lift it up,
pull it slightly towards you and make sure that the tab
support is in its proper seating.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
REMOVING AND REFITTING THE DOOR
1. To remove the door,
open it fully and lower the
catches until they are in the
unlock position.
2. Close the door as much
as you can. Take a firm
hold of the door with both
hands– do not hold it by
the handle. Simply remove
the door by continuing
to close it while pulling it
upwards at the same time
until it is released from its seating. Put the door to one
side, resting it on a soft surface.
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating
and securing the upper part onto its seating.
4. Lower the door and
then open it fully. Lower the
catches into their original
position: Make sure that
you lower them down
completely.
Apply gentle pressure to
check that the catches are in the correct position.
5. Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat
the steps above: The door could become damaged if
it does not work properly.
REPLACING THE LAMP
1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
Please note: Use 25 W/230 V type G9, T300 °C halogen lamps.
The bulb used in the product is specically designed for
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales Service. - Do not
handle bulbs with your bare hands as your ngerprints could
damage them. Do not use the oven until the light cover has
been retted.
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.
b
a
a
b
~15°
b
a
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht BAR2S K8 V2 IN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht BAR2S K8 V2 IN in the language / languages: English as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht BAR2S K8 V2 IN

Bauknecht BAR2S K8 V2 IN User Manual - German - 8 pages

Bauknecht BAR2S K8 V2 IN User Manual - Dutch - 8 pages

Bauknecht BAR2S K8 V2 IN User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info