806735

Bauknecht B7U HP43 X Manual

5
Zoom out
Zoom in
Previous page
1/6
Next page
EN
5
Daily Reference Guide
CLEANING THE SPRAY ARMS On occasions, food residue
may become encrusted onto
the spray arms and block the
holes used to spray the wa-
ter. It is therefore recommen-
ded that you check the arms
from time to time and clean
them with a small non-me-
tallic brush.
To remove the upper spray
you must remove it together
with the manifold.
The lower spray arm may be removed
by pulling it upwards and rotating it
anti-clockwise. Mounting back the
spray arm is by pulling it down and
rotating it clockwise.
The top spray arm may be removed
by pressing it up and then rotating it
anti-clockwise. Mounting back the
spray arm is by pulling it upwards and
rotating it clockwise.
TROUBLESHOOTING
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the following list.
For other errors or issues please contact authorized After-sales Service whose contact details can be found in the warranty booklet.
Spare parts will be available for a period of either up to 7 or up to 10 years, according to the specic Regulation requirements.
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The salt
indicator is lit Salt reservoir is almost empty. Rell the reservoir with salt (for more information - see FILLING THE SALT RESERVOIR).
Check the water hardness setting if necessary - see WATER HARDNESS TABLE.
The salt
indicator is
blinking Salt reservoir is empty. Rell the reservoir with salt as soon as possible. Using the appliance without salt may cause
damage to its internal components.
The rinse aid
indicator is lit
or blinking
Rinse aid dispenser is empty. (After rell the rinse
aid indicator may remain lit for a short time). Rell the dispenser with a rinse aid (for more information - see FILLING THE RINSE AID DISPEN-
SER).
Descale indicator
is lit or blinking;
«dES»
alarm is
displayed.
Limescale is accumulating on internal components of
the appliance.
Descale the appliance immediately using the Self Clean program and a commercially available
descaling product (see OPTIONS AND FUNCTIONS). Rell the reservoir with salt. Check the water
hardness setting. If the appliance is not descaled, it will stop functioning.
The dishwasher
won’t start or does
not respond to
commands.
The appliance has not been plugged in properly. Insert the plug into the socket.
Power outage. For safety reasons, the dishwasher will not restart automatically when power returns.
Close the door and press START/Pause button.
The dishwasher door is not closed.
ActiveDry pin is not pulled in. Vigorously push the door until you hear the “click”.
A cycle is interrupted by the door opening for
more than 4 seconds. Close the door within 4 seconds and press START/Pause button.
The control panel does not respond or F6 E1 is
displayed.
Switch o the appliance by pressing the ON-OFF/Reset button, switch it back on after approxima-
tely one minute and restart the program. If the problem persists, unplug the appliance for
1 minute, then plug it back in.
The dishwasher
won’t drain.
Display shows:
F7 E3 or F9 E1
The lter is clogged with food residues or limescale. Clean the lter and descale the appliance (see CLEANING THE FILTER ASSEMBLY and DESCALE
INSTRUCTION).
The drain hose is kinked. Check the drain hose (see INSTALLATION INSTRUCTIONS).
The sink drain pipe is blocked. Clean the sink drain pipe.
The dishwasher
makes excessive
noise.
Dishes are rattling against each other. Position the crockery correctly (see LOADING THE RACKS).
An excessive amount of foam is present.
The detergent has not been measured out correctly or it is not suitable for use in dishwashers
(see FILLING THE DETERGENT DISPENSER). Restart the current cycle by switching OFF the dishwa-
sher, then switch it on again, select a new program, close the door and press START/Pause
button. Please do not add any detergent.
Crockery has not been arranged properly. Arrange the crockery correctly (see LOADING THE RACKS).
The lter is clogged with food residues or limescale. Clean the lter assembly (see CARE AND MAINTENANCE).
The dishes are not
clean.
Crockery has not been arranged properly. Arrange the crockery correctly (see LOADING THE RACKS).
Spray arms cannot rotate freely, being hindered by
the dishes. Arrange the crockery correctly (see LOADING THE RACKS). Check that the upper rack is in the
correct position and adjust (lift up) if necessary.
The wash cycle is too gentle. Select an appropriate wash cycle (see PROGRAMS TABLE).
An excessive amount of foam is present.
The detergent has not been measured out correctly or it is not suitable for use in dishwashers
(see FILLING THE DETERGENT DISPENSER).
The cap on the rinse aid compartment has not
been closed correctly. Make sure the cap of the rinse aid dispenser is closed.
The lter is clogged with food residues or limescale. Clean the lter and descale the appliance (see CLEANING THE FILTER ASSEMBLY).
The salt reservoir is empty. Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht B7U HP43 X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht B7U HP43 X in the language / languages: English as an attachment in your email.

The manual is 9.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht B7U HP43 X

Bauknecht B7U HP43 X User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info