806730

Bauknecht B7I HF60 TUC Manual

4
Zoom out
Zoom in
Previous page
1/6
Next page
EN
4
CARE AND MAINTENANCE
2
1
4
3
A
A
B
C
CLEANING THE FILTER ASSEMBLY
Regularly clean the lter assembly so that the lters do not clog and that
the waste water ows away correctly.
Using the dishwasher with clogged lters or foreign objects inside the l-
tration system or spray arms may cause unit malfunction resulting in loss of
performance, noisy work or higher resources usage.
The lter assembly consists of three lters which remove food residues
from the washing water and then recirculate the water.
The dishwasher must not be used without lters or if the lter is loose.
At least once per month or after every 30 cycles, check the lter assembly
and if necessary clean it thoroughly under running water, using a non-me-
tallic brush and following the instructions below:
1. Turn the cylindrical lter A in an anti-clockwise direction and pull it out
(Fig 1). It is important when reinstalling the lter that the two trian-
gles shown on the zoom meet.
2. Remove the cup lter B by exerting a slight pressure on the side aps
(Fig 2).
3. Slide out the stainless-steel plate lter C (Fig 3).
4. In case you nd foreign objects (such as broken glass, porcelain,
bones, fruit seeds etc.) please remove them carefully.
5. Inspect the trap and remove any food residues. NEVER REMOVE the
wash-cycle pump protection (shown by an arrow) (Fig 4).
After cleaning the lters, replace the lter assembly and x it in
position correctly; this is essential for maintaining the ecient
operation of the dishwasher.
LOADING THE RACKS CAPACITY: 15 standard place-settings
CUTLERY RACK
The third rack was designed to house the
cutlery.
Arrange the cutlery as shown in the gure.
A separate arrangement of the cutlery makes
collection easier after washing and improves
washing and drying performance.
Knives and other utensils with sharp edges
must be positioned with the blades facing
downwards.
The cutlery rack is equipped with two sliding
side trays to make the most of the height of the
space below and enable the loading of high
items into the upper rack.
UPPER RACK
Load delicate and light dishes: glasses, cups,
saucers, low salad bowls.
The upper rack has tip-up supports which can
be used in a vertical position when arranging
tea/ dessert saucers or in a lower position to
load bowls and food containers.
(loading example for the upper rack)
Adjusting the height of the upper rack
The height of the upper rack can be adjusted: a high position to place bulky
crockery in the lower basket and low position to make the most of the tip-up
supports by creating more space upwards and avoiding collision with the
items loaded into the lower rack.
The upper rack is equipped with an Upper Rack height
adjuster (see gure), without pressing the levers, lift it
up by simply holding the rack sides, as soon as the rack is
stable in its upper position. To restore to the lower posi-
tion, press the levers A at the sides of the rack and move
the basket downwards.
We strongly recommend that you do not adjust the
height of the rack when it is loaded.
NEVER raise or lower the basket on one side only.
Foldable aps with adjustable position
The side foldable aps can be folded or unfolded
to optimize the arrangement of crockery inside
the rack. Wine glasses can be placed safely in the
foldable aps by inserting the stem of each glass
into the corresponding slots.
Depending on the model:
• to unfold the ap there is needed to slide it up
and rotate or release it from the snaps and pull
it down.
• to fold the ap there is needed to rotate it and
slide ap down or pull it up and attach ap to
the snaps.
LOWER RACK
For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids should
ideally be placed at the sides to avoid interferences with the spray arm.
The lower rack has tip-up supports which can be used in a vertical position
when arranging plates or in a horizontal position (lower) to load pans and
salad bowls easily.
(loading example for the lower rack)
POWER CLEAN®
Power Clean® uses the special water jets in the
rear of the cavity to wash more intensively the
highly dirty items. The lower rack has a Space
Zone, a special pull-out support in the rear of
the rack that can be used to support frying
pans or baking pans in an upright position,
thus taking up less space.
Placing the pots/casseroles faced to the
Power Clean® component please activate the
POWER CLEAN® on the panel.
How to use the Power Clean®:
1. Adjust the Power Clean® area G folding
down the rear plate holders to load pots.
2. Load pots and casseroles inclined vertically
in the Power Clean® area. Pots have to be
inclined towards the powerful water jets.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht B7I HF60 TUC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht B7I HF60 TUC in the language / languages: English as an attachment in your email.

The manual is 9.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht B7I HF60 TUC

Bauknecht B7I HF60 TUC User Manual - German - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info