Manual Batavus Milano E-go (page 34 of 83) (English, German, Dutch, Danish, French)

779537

Zoom out

Zoom in

1/83

English–10

Bosch eBike Systems 0 276 001 SAI | (14.8.13)

Inserting and Removing the Battery Pack

(see figures C–D)

fAlways switch the battery pack off when inserting or

removing it from the holder.

In order for the battery pack to be inserted, the key A5 must

be inserted into the lock A6 and the lock must be unlocked.

To insert the standard battery pack A8, place it with the

contacts on the lower holder A9 on the eBike (the battery

pack can be inclined up to 7° to the frame). Tilt it into the up-

per holder A7 until it engages.

To insert the rack-type battery pack A2, slide it with the

contacts facing ahead until it engages in the holder A1 of the

rear rack/carrier.

Check if the battery pack is tightly seated. Always lock the

battery pack with lock A6, as otherwise the lock can open and

the battery pack could fall out of the holder.

After locking, always remove the key A5 from the lock A6.

This prevents the key from falling out and the battery pack

from being removed from unauthorised persons when the

eBike is parked.

To remove the standard battery pack A8, switch it off and

unlock the lock with the key A5. Tilt the battery pack out of the

upper holder A7and pull it out of the lower holder A9.

To remove the rack-type battery pack A2, switch it off and

unlock the lock with the key A5. Pull the battery pack out of

the holder A1.

Operation

Initial Operation

fUse only original Bosch battery packs approved for

your eBike by the manufacturer. Using other battery

packs can lead to injuries and pose a fire hazard. When

using other battery packs, Bosch shall not assume any

liability and warranty.

Switching On and Off

Switching the battery pack on is one of the possibilities to

start the eBike system. Read and observe the operating in-

structions of the drive unit and the drive HMI.

Before switching on the battery pack or the eBike system,

check that the lock A6 is locked.

To switch on the battery pack, press the On/Off button A4.

The LEDs of indicator A3 light up and at the same time indi-

cate the charge condition.

Note: When the battery-pack capacity is below 5 %, none of

the LEDs of charge-control indicator A3 will light up. Only the

drive HMI will indicate if the eBike system is switched on.

To switch off the battery pack, press the On/Off button A4

again. The LEDs of indicator A3 go out. This also switches off

the eBike system.

When no power output of the eBike drive is requested for ap-

prox. 10 minutes (e. g., because the eBike is parked) and no

button of the drive HMI or operating unit is pressed, the eBike

system and thus the battery pack automatically switch off to

save energy.

The battery pack is protected against deep discharging, over-

charging, overheating and short-circuiting through the “Elec-

tronic Cell Protection (ECP)”. In case of hazardous situations,

a protective circuit automatically switches off the battery

pack.

When a defect of the battery

pack is detected, two LEDs of

the charge-control indicator A3

flash. In this case, please refer

to an authorised bicycle dealer.

Notes for Optimum Handling of the Battery Pack

The battery-pack life can be prolonged when being properly

maintained and especially when being operated and stored at

the right temperatures.

With increasing age, however, the battery-pack capacity will

diminish, even when properly maintained.

A significantly reduced operating period after charging indi-

cates that the battery pack is worn out and must be replaced.

You can replace the battery pack yourself.

Recharging the Battery Pack prior to and during Storage

When not using the battery pack for a longer period, charge it

to approx. 60 % (3 to 4 LEDs lit on the charge-control indica-

tor A3).

Check the charge condition after 6 months. When only one

LED of the charge-control indicator A3 lights up, recharge the

battery pack again approx. 60 %.

Note: When the battery pack is stored discharged (empty) for

longer periods, it can become damaged despite the low self-

discharging and the battery-pack capacity may be strongly re-

duced.

It is not recommended to have the battery pack connected

permanently to the charger.

Storage Conditions

Store the battery pack in a dry, well-ventilated location. Pro-

tect the battery pack against moisture and water. Under unfa-

vourable weather conditions, it is recommended e.g. to re-

move the battery pack from the eBike and store it in an

enclosed location until being used again.

The battery pack can be stored at temperatures between

–10 °C and +60 °C. For a long battery-pack life, however,

storing the battery pack at a room temperature of approx.

20 °C is of advantage.

Take care that the maximal storage temperature is not ex-

ceeded. As an example, do not leave the battery pack in a ve-

hicle in summer and store it out of direct sunlight.

It is recommended to not store the battery pack on the bike.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Batavus Milano E-go in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 9.65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Batavus Milano E-go Manual

Product: